Cheap Halogens Occasionally Flickering

[lumenmachine]

Hello,

Had a call-out today for a lady who was concerned about 'flashing' lights throughout her house. The 'flashing' happens about once every 10 minutes, and the lamp essentially goes off for a split second. The issue happens across both of the lighting circuits. I've checked at the board and within the lighting JBs in the attic for loose connections but everything is nice and tight. The only thing I can think of is that the cheap halogen GLS lamps in use are causing this to happen, although I'm having trouble thinking of a reason why they would do this (if they even are).

Any thoughts appreciated!

 

[Octopus]

Replace a lamp with a decent brand .................. did you check the incoming tails at the CU and the meter and the head?

Is there sizzling or crackling from the DNO head?

 

[lumenmachine]

Checked the lot, I reckon it's the lamps and I'm over-thinking it. The 'flashing' happens independently; i.e. when the lounge light 'flashes' the kitchen doesn't etc.

 

[Squid]

Tell her all her neighbours have the "expensive" ones.

 

[camerabloke]

Are they leds

 

[lumenmachine]

No, just the Halogen GLS lamps you get instead of Filament lamps nowadays.

 

[buzzlightyear]

Had a call-out today for a lady who was concerned about 'flashing' lights throughout her house. The 'flashing' happens about once every 10 minutes, and the lamp essentially goes off for a split second. The issue happens across both of the lighting circuits. I've checked at the board and within the lighting JBs in the attic for loose connections but everything is nice and tight. The only thing I can think of is that the cheap halogen GLS lamps in use are causing this to happen, although I'm having trouble thinking of a reason why they would do this (if they even are).

it was not close encounters was it?

 

[Octopus]

Did you check ALL the CU connections? including checking the buzz bars are the correct side of the clamps

 

[buzzlightyear]

No, just the Halogen GLS lamps you get instead of Filament lamps nowadays.

not seated write in the pins !

 

[Squid]

Are they leds

There is a clue in the title.......

 

[lumenmachine]

Did you check ALL the CU connections? including checking the buzz bars are the correct side of the clamps

Yes, Checked the lot; nothing amiss

 

[buzzlightyear]

Yes, Checked the lot; nothing amiss

no contact then!

 

[Octopus]

Have you seen it happen?

 

[lumenmachine]

Have you seen it happen?

Yes, I was really hoping it was 'all in her head'

 

[Octopus]

Nice .........

So its all rooms, both circuits, and you say ALL the connections are tight ...............

my money is on the incoming supply / connections