Extend SWA to consumer unit

[Gavfromengland]

Hi guys. I have an old out building that has been knocked down and in it’s place an extension is being built. The old out building had a ring and a lighting circuit with water heater for a shower all fed From a ccu that came from the main house through 10mm swa. The extension is now going to be fed from this same ccu. However I want to move the original position of the ccu. Can I extend this SWA? And how??

 

[Vortigern]

Wiska Shark is what you want.

 

[GBDamo]

Surely it can be pulled back and channeled through the floor then back up the wall?

 

[Dustydazzler]

Grinder , small chase , get in in the floor and up the opposite wall.

no need to joint

 

[GBDamo]

It is a concern, but to be honest I would chase out the floor and take it across to the other wall, or just tell her it, cant be moved. ?

Oops ?, didn't see youd already suggested the obvious.

 

[GBDamo]

Grinder , small chase , get in in the floor and up the opposite wall.

no need to joint

This is getting silly now....

 

[Mike Johnson]

It's as my Farther used to say about some of my friends "If he had an original thought, it would be lonely" ?

 

[radiohead]

What are those cables in capping above the door? They are not in a safe zone and non-compliant if mains voltage, unless they only come down 150mm..

 

[telectrix]

What are those cables in capping above the door? They are not in a safe zone and non-compliant if mains voltage, unless they only come down 150mm..

that's a 9" cinder/concrete block. add the timber ad the drop is about a foot. ( that's 300millipededs for the young sprogs).

 

[radiohead]

that's a 9" cinder/concrete block. add the timber ad the drop is about a foot. ( that's 300millipededs for the young sprogs).

Doesn't mean the cables go all the way down the capping though....but I suspect they will do.

 

[telectrix]

uless it's an outside lightover the door. that would make sense.

 

[Gavfromengland]

Cable isn’t long enough. Chased through the floor or not. Capped cable not ideal but is literally the closest to 150mm it could go as it feeds outside light. Couldn’t go any higher due to roofing.

 

[brianmoooore]

Hole through wall should have been drilled upwards at an angle from the outside, so that it is more than 50mm deep inside when out of the safe zone.
That SWA looks plenty long enough in the pic. to reach across the floor and up the wall to a CU at the correct height. Are you sure it's not long enough?

 

[Gavfromengland]

Yeah not long enough. Height is fine but would be directly behind the door.

 

[Micktw68]

nobody advising a choc block and tape? obviously no builders following this thread.

I know...The standards on this forum have really dropped lately. So disappointing.

 

[7029 dave]

Yeah not long enough. Height is fine but would be directly behind the door.

Fit it above the door, all cables will reach including the SWA.