Here’s one for you....

[MFS Electrical]

tidying out my wardrobe earlier on - don’t ask but I came across a little LED strip that I got in B&M years ago it’s rigid and fully encased I was wondering if anyone had any ideas on how to fix it to the top slider rail of the wardrobe it did come with brackets but they are long lost. I did think double sided tape but doubt it would hold it for very long and I’d probably be sticking it back up every other week..... anyways see my crude drawing of the general shape and where I want to fit them (the green dot) I was thinking maybe P clips anyone have any better suggestions?

 

[stevels4]

I’m not a plumber how dare you insinuate i own a gas torch it would work but I bet the circuit board would melt

I’m not a plumber either but do have a gas torch..how else could I heat shrink break out boots and sleeving?

 

[Deuce]

I’m not a plumber either but do have a gas torch..how else could I heat shrink break out boots and sleeving?

Heat gun.

 

[Pete999]

What he said^^^^^^^^^^^^^^^^^^^^^^

 

[MFS Electrical]

Lighter?

 

[Dave OCD]

Just use large T&E clips and substitute the pins for thin screws.

 

[w0z]

Self adheasive velcro?

Whenever I've used it the self-adhesive bit eventually falls off no matter how well prepared the surface is, but the velcro part is good!