Impact vs combi drill for drilling holes

[joehat]

Re: Impact vs conbi drill for drilling holes

Look up impacts drilling holes on YouTube and get back to me on what you think!!!

 

[Barry White]

Re: Impact vs conbi drill for drilling holes

Not standard wood but but the Bosch devel bit, it basically has the screw bit on the end that pulls it through

Ok have a few of then somewhere will give it a try sometime.

 

[joehat]

Re: Impact vs conbi drill for drilling holes

Also the dewalt one state it's suitable for impacts

 

[joehat]

Re: Impact vs conbi drill for drilling holes

 

[joehat]

Re: Impact vs conbi drill for drilling holes

 

[joehat]

Re: Impact vs conbi drill for drilling holes

Ok have a few of then somewhere will give it a try sometime.

Let me know what you think, you tube has videos of them

 

[Swcfisher]

Re: Impact vs conbi drill for drilling holes

The armeg beavers have the screw on the front.

 

[joehat]

Re: Impact vs conbi drill for drilling holes

Yes they do but because there more aggressive they make a rougher exit, haven't tried but the videos show so

 

[amlu]

Re: Impact vs conbi drill for drilling holes

I use a small but powerful Bosch mains drill (GSB16RE). No point knackering expensive batteries on butchering wood.

 

[shanky887614]

Re: Impact vs conbi drill for drilling holes

which makita drill are you using? i find with my 481 it doesnt struggle at all and i rarely have to put it in gear 1. (quicker than impact driver) as soon as the torque starts to build my impact driver almost stops dead

irwin auger bits for me

 

[joehat]

Re: Impact vs conbi drill for drilling holes

Mines the standard one with the kit, but don't use much so doesn't warrant me buying and exsoencive one, as I only do domestic and self employed. Also the impact is nice and short.

 

[joehat]

Re: Impact vs conbi drill for drilling holes

 

[joehat]

Re: Impact vs conbi drill for drilling holes

 

[joehat]

Re: Impact vs conbi drill for drilling holes

Basically the kit ones rubbish!!

 

[Skimpy Wan]

Re: Impact vs conbi drill for drilling holes

I burnt the same drill out drilling a 2" joist with a brand new 16mm spade bit - it was smoking for about 5 minutes afterwards.

Went straight back to Screwfix and got a refund. Ended up buying this bad boy ...

http://www.makitauk.com/products/co...s-kits/dlx2040spe-18v-lxt-2pcs-combo-kit.html

Combi-drill is brilliant and 5A batteries, on a brushless body, last a lot longer.