Link between N - CPC on fluorescent... what is it?

[NDG Elecs]

Hello folks,

I hope the picture shows ok. If it does not show, then basically there is a blue disc approx 25mm in diameter that may have a resistor or something in it. It is approx 4mm ' thick'.

The blue disc is linking between neutral and earth on the fitting. Never noticed these before and the casing of the fitting is live when energised, which is not good!

Fluorescent's puzzle me at the best of times!

Thanks.

 

[DPG]

Looks like a varistor/surge arrestor. Daz

 

[telectrix]

i'd have expected that to be across L and N. and what means are you using to determine that the casing is live?

 

[NDG Elecs]

Thanks Daz,

Can these be omitted. Only one fitting out of five in total had it in. And didn't have time to check thoroughly but it may be causing a N-E fault.

Thanks

 

[SPARTYKUS]

Capacitors used to look like that. In old days, like.

micro farads to the lot of yer.


as tel says not sure what its doing there

 

[Zebra Stripe]

Agree with tel above, should be across L & N like capacitor for PF correction...maybe its a dummy load "thingy" usually installed for some makes of PIR switch although should still be between L&N.

load "thing" = load capacitor

 

[telectrix]

take it out. cut the leads off. use it for tiddlywinks.

 

[NDG Elecs]

Cheers Tel, bit short on time so will get back to you later but was initially doing an R2 to the fittings and all CPCs were open cct. Bit puzzled as this cct rewired 4 years ago. Found the problem at switch where no continuity between CPCs. Anyway, when the lights were on I touched the casing and got a tingle. So tested with mft and a fluke t5 between MET and the casing. Got 230v both times.

Thanks

 

[Zebra Stripe]

Definately will be causing a N-E fault and could be making fitting live IMO

 

[guest119]

At the top of the picture it looks like your earth is not connected.
The capacitor is a transient voltage arrestor (cheap fittings).
If your fitting is showing live at all times then you need to check polarity, even as far back as the meter.
So, no earth, capacitor across live (blue wire) and case.
Boydy

 

[GLENNSPARK]

At the top of the picture it looks like your earth is not connected.
The capacitor is a transient voltage arrestor (cheap fittings).
If your fitting is showing live at all times then you need to check polarity, even as far back as the meter.
So, no earth, capacitor across live (blue wire) and case.
Boydy

it is connected...the earth tag is at the bottom of the connector block...as is the twin`s CPC...

 

[benji]

whats happening to the tw&e at the top of picture

 

[GLENNSPARK]

whats happening to the tw&e at the top of picture

rodents..

 

[telectrix]

top of pic is missing. looks like some connectable has been done.ion/extension of c

 

[tazz]

It is as stated earlier a surge suppressor, but it has been install incorrectly. Should be across L & N. Only really used to protect sensitive electronic equipment, such as alarms and psu`s....wont do any harm removing it from a fluorescent fitting.