Looking for advice with a self made c/u

[martinh89]

Afternoon, I've spent the day looking for an ip55 or above 6way single phase c/u... Its to be installed inside an enw substation and from past experience they don't expect the metal enclosed c/u, so long story cut short, I've got an ip65 enclosure with dim rail but I'm not sure how to fit a neutral and earth bar as its not come with them.. .. Any advice would be much appreciated

 

[martinh89]

Bit of an up date..... So after arriving on site and speaking to the foreman I discovered that I'm the first person to attend site from the electrical department . .. . Long story cut short, the lv panel came already fitted with a bulkhead and an rcd protected socket, so no need for any small wiring and botched consumer unit did this instead

 

[martinh89]

Bit of an up date..... So after arriving on site and speaking to the foreman I discovered that I'm the first person to attend site from the electrical department . .. . Long story cut short, the lv panel came already fitted with a bulkhead and an rcd protected socket, so no need for any small wiring and botched consumer unit did this insteadView attachment 47893

 

[DPG]

Blimy that was a few wasted hours then - are they paying you for that?

 

[martinh89]

Yep... I get day rate upto 10 hours and time and half after so there definitely getting a bill

 

[Jjc]

But don't you have en externally exposed bolt head connected to neutral?

Correct rough ad

useful test point, or bit of gaffer tape will sort out.

Rough as a badgers

 

[EalingBadger]

Rough as a badgers

Oi!