Meter tail grommets

[xylophone]

Can the hive mind tell me where I can source the meter tail grommets that pack a 16mm insulated/sheathed tail up to 25mm? The Henley block knockouts are for 25mm cable and I want to maintain the IP rating for existing 16mm.
I may use heatshrink as a solution but I know these things exist because I’ve seen DNO/Meter fitters with them in the past

thanks in advance

T

 

[James]

This is a question that has been asked before, it was answered but I can’t remember the title.

Try a search of the forum
[automerge]1600173626[/automerge]
Found it

Cable ID collars (often found after a meter upgrade | on ElectriciansForums

Find Cable ID collars (often found after a meter upgrade Advice and Help. How-to Cable ID collars (often found after a meter upgrade in the Electrical Tools and Products advice boards on ElectriciansForums.net Est.2006 | Free Electrical Advice Forum. Cable ID collars (often found after a meter...

www.electriciansforums.net

 

[xylophone]

Thanks @James for this... its subtly different I think since these collars are for identification, not IP... will continue to trawl...

T.

 

[James]

You might have missed this post.

Security Collars | Revenue Protection | Custom Design Group

Custom Design Group. Specialist cable supplier and manufacturer of moulded electrical connectors for airfields, railways, utility, underwater & bespoke applications

www.cdg-uk.com

They will improve the ip rating to an acceptable level

 

[Andy78]

I've never felt the need to improve the IP rating of a Henley block. Am I missing out on something ?

 

[xylophone]

I've never felt the need to improve the IP rating of a Henley block. Am I missing out on something ?

the knockouts in the thermoset plastic are for 25mm.Some have terminals at the top and bottom and a combination of top entry and existing 16mm tails leaves a tiny gap. Not unsafe, but ingressable.
Maybe I should have mounted them sideways ?

 

[Andy78]

the knockouts in the thermoset plastic are for 25mm.Some have terminals at the top and bottom and a combination of top entry and existing 16mm tails leaves a tiny gap. Not unsafe, but ingressable.
Maybe I should have mounted them sideways ?

Ah right. I've only ever used the ones with all the entries on one side of the block

 

[ChrisElectrical88]

Ah right. I've only ever used the ones with all the entries on one side of the block

Click Henley blocks only have entry from one angle. Decent kit but are lacking for a decent top entry.

 

[littlespark]

Strike me down, but the proteus blocks have replaceable shields for unused ways.... handy if you take out tails and are left with a hole.

strike me down again for suggesting wrapping insulating tape around the cable to bulk it out a bit

 

[MJPD29]

Ah right. I've only ever used the ones with all the entries on one side of the block

I agree, I dont see the need either. I've never done it anyway.