pendent problems BIG TIME

[HandySparks]

BS 7672:1993

Specification for compression, stiffness and labelling of anti-embolism hosiery

 

[Fast&Rough]

Snip some of the strands off lol

 

[decolad69]

Just first fixed a new lighting circuit it a domestic dwelling I've wired it in 6mm t&e to avoid any vd over the 20m circuit. Now here's the tricky bit how the hell do I second fix this into a pendent, I was thinking of cutting some strands of the cores, will this comply with bs7672?

Your problem is you real should have used 10mm t&e ! to avoide VD ........... ask the boys at ScrewFix if it comples with bs 7672.5

 

[telectrix]

should have gone to B&Q. step by step guide on DIY electrocution available there.

 

[Geordie Spark]

Your problem is you real should have used 10mm t&e ! to avoide VD ........... ask the boys at ScrewFix if it comples with bs 7672.5

If you're serious about wanting to avoid VD you need this: Condoms Home

 

[Engineer54]

Snip some of the strands off lol

Some?? Don't you mean most?? 12mm of conductor going into a terminal on a pendant rose!! Something i'd like to see!! lol!!

 

[chrish_1977]

This post + mouth full of coffee = wet phone

 

[thomas-1981]

If you could upload a pic I would be happy to tell you, your a wind up merchant.

 

[thekernal]

very funny

 

[snowhead]

6mm,,,I think it's a wind up and he's really done it in 4mm.

 

[kingeri]

Aaargh not another wind up thread. Why do it. Nothing on telly?

 

[Rockstar94]

You should of wired it in bell wire, coiled it up a couple of times then not only do you have a great light source but a great room heater too!!

 

[TAZ]

It's 100w per point not 1000w

 

[Elmer BeFuddled]

It's 100w per point not 1000w

From Gremlins:

"Bright light! Bright light!"

Perhaps the 6mm is the overall dimension of the grey sleeve (measured badly!!)?

 

[TAZ]

Nice to know someone understands the meaning of diversity with out going over the top!!!