Pulling main cut out fuse

[Irish Mick]

I am aware this topic has been raised before, however, I was at a job this week where a new consumer unit is to be fitted.

I have asked the owner to contact the supplier to arrange for an isolator to be added between the old board and the meter.

On doing so, The supplier has stated the rules had changed and the electrician can cut the tag and remove the fuse to isolate.

Needless to say, I am far from happy with this so asked the owner to call them again. This time they said when I am at the job to call them and speak to them for authority. Again, I am stilk not happy and am presently refusing to do the job without a fitted isolator.

My understanding is WPD are the owner and only they should be doing such things.

Does anyone have any thoughts or heard anything to the contrary?

Thanks

 

[Deleted member 105166]

Get your customer to speak to the supplier whilst you're there with them, it could just be a case of how the question was asked.

 

[Baddegg]

That might be because for every job you are supposed to do a risk assessment/method statement and as a scheme member that's what you are expected (in theory) be doing.

Yes I have a generic RA,but I’ll be honest the fairies always seem to beat me to the seals anyway......

 

[Midwest]

SSE told me,over the phone admittedly, that as long as you are registered with a scheme you can pull the fuse and let them know afterwards.....

SSE does have policy for domestic single phase supplies, if you search for procedure for removal & replacement of company cut-out seals by electrical contractors.

After completion of your works, use their temporary seals, and give them the details, to re-seal. Course you should carry out a risk assessment of the condition of the cut-out (i.e. removing main fuse) before doing so, and wear appropriate PPE.

 

[Midwest]

I do recall these policies & procedure were being reviewed by the Energy Networks Association, to have a common approach. But I wouldn't be holding my breath.

 

[Irish Mick]

I do recall these policies & procedure were being reviewed by the Energy Networks Association, to have a common approach. But I wouldn't be holding my breath.

Thanks for the replies guys. Think I best speak to them as advised.

 

[JK-Electrical]

SSE does have policy for domestic single phase supplies, if you search for procedure for removal & replacement of company cut-out seals by electrical contractors.

After completion of your works, use their temporary seals, and give them the details, to re-seal. Course you should carry out a risk assessment of the condition of the cut-out (i.e. removing main fuse) before doing so, and wear appropriate PPE.

I've uploaded the relevant document as a PDF file.