Scrap cable stripper......

[Baddegg]

anyone recommend a scrap cable stripper?

 

[buzzlightyear]

try this ,LOL.

 

[Baddegg]

Nah that’ll hurt the Mrs hands,I’m not a complete savage I’ll buy her a decent (manual) one!

 

[Rosco]

Manual Copper Wire Stripping Machine Cable Stripper Scrap Metal Recycle Tool 657258017269 | eBay - https://www.ebay.co.uk/itm/253773267527
This is great if you take the handle of you can put your drill straight onto it.

 

[Rocboni]

Heres my homemade one, can do upto 120mm singles or armour cores (not tried anything bigger)
Also does T&E on the other side but never really use it as it's hardly worth it.

 

[Strima]

Manual Copper Wire Stripping Machine Cable Stripper Scrap Metal Recycle Tool 657258017269 | eBay - https://www.ebay.co.uk/itm/253773267527
This is great if you take the handle of you can put your drill straight onto it.

That's what I use with a drill, certainly makes life a lot easier.

 

[Baddegg]

Thanks chaps I’m looking at the one rosco recommends just wanted some confirmation others had used

 

[mickfred]

Have you tried cableknife . It easy and does work (not a machinei know)

 

[Baddegg]

Sounds like hard work mick...

 

[pirate]

That's a beast rocboni!
Do you steal...ahem, acquire, lots of cable? LOL!
I have a modest few drums of old colour cable and had a look on fleabay where the going rate is a couple of quid and more for the old 2.5 t&e...hardly seems worth stripping it if I can sell a drum for ££££s

 

[Rocboni]

I do seem to acquire a lot of cable, usually because it is overordered, (not buy me) Or strip out quite a bit, got a load of 120mm armoured to strip ATM, an this only cost me about £20 for the motor off eBay. I had everything else or made it, I've got an inverter on it to control the speed. Had thousands through it to date.

 

[KEV 1 N]

 

[Rocboni]

Obviously

 

[Baddegg]

Goes without saying officer.....

 

[Tes369]

anyone recommend a scrap cable stripper?

It's called an apprentice in a room with all the scrap cable piled up and a heater left on to soften the insulation. He gets a cut same as everybody else. I've seen them stripping cable and left out it's a terrible thing to do.

* Kevlar woven glove on non knife holding hand cut away from the body.

Cheers