scotta032013
DIY
Hello all,
I have a tail light for a '12 Ducati Panigale 1199 S, that I can't get working properly. The brake light / daytime running lights work fine through the factory connector. The turn signals are the problem, they do not work independently - they flash like hazard lights.
The tail light only has the 'hot' wire for each blinker (no ground) and comes with a resistor to be installed as well. I've added a summary below of the wires shown in the attached picture. Any help would be greatly appreciated.
Thank you kindly
I have a tail light for a '12 Ducati Panigale 1199 S, that I can't get working properly. The brake light / daytime running lights work fine through the factory connector. The turn signals are the problem, they do not work independently - they flash like hazard lights.
The tail light only has the 'hot' wire for each blinker (no ground) and comes with a resistor to be installed as well. I've added a summary below of the wires shown in the attached picture. Any help would be greatly appreciated.
- Red arrows indicate the turn signal wires from the new tail light (hot only)
[*]Green arrows indicate factory turn signal wires (hot / ground)
[*]Black arrow indicates the resistor that should be wired in as well.
Thank you kindly
![[ElectriciansForums.net] Tail light wiring help needed please - Panigale 1199 S](https://electricians.s3.eu-west-1.amazonaws.com/data/attachments/75/75561-970c9a7ff5b60a2b45a1716beb19820f.jpg)
