Traying a swa round a corner

[cliffed]

Thoughts on this,it’s a 70mm 4 core swa.

 

[johnduffell]

If you can cope with a height change you can curve to vertical before the corner and back to horizontal after. That would work mathematically but practically and aesthetically it may leave much to be desired!!

 

[Squid]

Must admit I would have had the bricks out, set the cable through and then rebrick it into the wall.

How about drilling a large hole through the wall and feeding the cable through?

I remember at Heathrow using a 5 Tonne lorry to drag an armoured through.

 

[Flanders]

I would change those tie raps for metal the plastic ones will go brittle , not a bad job though its always easy afterwoulds to think of a beter way of doing it , may be swan neck to tray back closer to the wall next time

 

[cliffed]

Must admit I would have had the bricks out, set the cable through and then rebrick it into the wall.

I agree but others didnt

 

[cliffed]

I would change those tie raps for metal the plastic ones will go brittle , not a bad job though its always easy afterwoulds to think of a beter way of doing it , may be swan neck to tray back closer to the wall next time

Exactly thanks for that

 

[cliffed]

Can't understand why to keep it uniform the tray wasn't taken away from the wall pre bend then you go around the bend and take it back so it matches both sides.

Bit of a bodge methinks.........

And the radius isn't uniform around the bend, tsk, when I where a lad.............

Thanks