Search results | Page 4

Search results

  1. T

    Another bonding question

    Hi guys, Doing an eicr on a flat. Water is in plastic up to the boiler and no gas to the property. No bonding in place at the moment. Tncs system. Ir test to the met and get dead short, continuity .07ohms however when i disconnect the 2 earths (from 2 spurs) to the immersion heater i get a...
  2. T

    Swa on a fence

    Thats my plan, i cant see any major flaws in it, the fence is sturdy. A socket and 3 lights, to be used on the odd occasion. Done the calcs and a 2.5mm is suitable but ill run a 4mm to allow for future additions. Already done a board change and left a non rcd way for the garage and ill have...
  3. T

    Swa on a fence

    Had a bad day? I appritiate its not the best way but there arnt any other doable options. I just wanted to check i hadnt overlooked anything obvious, thats what these forums are fore isnt it?
  4. T

    Swa on a fence

    Cheers, i tried a search but on tapatalk its not very easy to go through the results. The fence is not a flimesy one that are in most gardens, its concrete pillars with stiff wooden fencing between. The existing pyro has been there for 20years plus. And ill get permission from next door first...
  5. T

    Swa on a fence

    Hi guys, Ive got to run an armored cable to a garage from a ground floor flat, the existing feed is pyro but its been vandalised and no good. The pyro is currently clipped to a fence owened by the people next door. This is the only route down to the garage, short of digging up the concrete...
  6. T

    Changing main switch on CU

    Whats the existing rating? And what type of premisis is it?
  7. T

    I dont think they should look like that

    You are correct, and i already know this, i even quoted it on my eicr today, but the beer is clouding my judgement, its too hard to resist i get 50% off food and drink in the hotel im in :)
  8. T

    I dont think they should look like that

    They couldnt even get the stickers straight
  9. T

    I dont think they should look like that

    Isnt it ip2x for top surfaces ;)
  10. T

    Primastar drivers seat

    Hi guys, As i seem to be spending more and more time in the van, does anyone know if you can get a decent seat for it? Im looking for all the stuff the existing ones got (up down, back forward) plus arm rests, cup holder and any other pointless accessories (that would make me feel better Ive...
  11. T

    I dont think they should look like that

    Tape? Im far too cheap to be spending my money on that overpriced stuff
  12. T

    I dont think they should look like that

    It was fine after i stanley off the excess plastic, who need insulation anyway ;)
  13. T

    I dont think they should look like that

    Doing an eicr in a hotel and the maintanence guy asked if i could take a look at an intermittantly tripping rcd. Rcd tested fine, so i started disconnecting the fittings for an ir test and found this. 200mm of kingspan, and unenclosed connector blocks sitting in the kingspan directly above a...
  14. T

    Pond Pumps ?

    I think there was a thread on here a while back about DP spurs. When you switch some of them off they take out the rcd because the line and neutral dont disconnect at the same exact monent causing an imbalence in the circuit. Tim
  15. T

    Very SMART, this meter!!!

    According to the yellow label you can only work on the system if you are NIC or ECA registared, looks like im out of work with my napit registration. The meter is a good idea though.
  16. T

    Going senile

    I was going to suggest you buy a safe to store all your valuables, but you may not remember the code. ;)
  17. T

    11kw shower cable size?

    What reference method?
  18. T

    Wiring PIR sensors looping in and out.

    Could you have run the loop out from the s/l of the first fitting causing the others to lose power when the first switches off then when it turns back on it automatically goes in to start up mode causing the repitive flashing for a few seconds Tim
  19. T

    17th full or update?

    I meant the 2330 or equivilent, that has an edition on it.
  20. T

    17th full or update?

    Do you city and guilds certs not have what edition you are on them?

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top