Search results

Search results

  1. Resu

    Economy 7 confusion

    That Newlec timer/switch will need to be left switched to "timed" for the offpeak to work - also worth checking the times it's set to actually line up with your offpeak tariff. The boost button utilises the 24 hour supply to boost the heat if you were to run out of hot water, typically limited...
  2. Resu

    Where is this?

    Looks like Paignton Pier
  3. Resu

    Hot water direct to solar panels

    They said they've already got PV. Eddi, Immersun, Solar iBoost all do immersion controllers. If thinking of an EV charger in the future then Eddi is already setup to work alongside the Zappi, etc. Had a client in the past with an Immersun and an EV Charger (can't remember brand but it was...
  4. Resu

    My favourite ! half moon plaster up light

    https://www.editlighting.com/edit-ealing-ceramic-wall-light.html These you can just hang off of two fixings. The up/down ones are better, you wire up the lampholder part and the plaster part just slots over the top. https://www.editlighting.com/edit-bexley-up-down-plaster-wall-light.html
  5. Resu

    Advice for timer for 3.4kw storage heater

    Can you not just adjust the input/output controls on the heater?
  6. Resu

    Smoke detector with separate backup batteries?

    I've read through that article a few times before. I'd argue that that entire section (particularly the final sentence) kind of leaves it open for interpretation that they're referring to the battery powered only detectors. We've only been fitting the 3016's since the introduction of the...
  7. Resu

    Smoke detector with separate backup batteries?

    Have you a source for that? Everything I've read stipulates the battery must be sealed/tamper proof if the detector is battery powered only.
  8. Resu

    Smoke detector with separate backup batteries?

    Sealed/tamper proof batteries only required for battery powered only alarms. I second the 3016, the backup battery is rechargeable so in theory would only need access in 10 years when the detector is due for replacement anyway.
  9. Resu

    Wire Pump to Diverter Valve ‘Brown’ or use a relay?

    Only issue I can think of is that the pump will be pushing on the valve for a few seconds until it opens up fully.
  10. Resu

    What a mathematical error!!!!

    More like measure once, join six times! Usually if we're pacing a couple of us would do it and take an average. Been a bit off a few times but usually the other way. 37m is alot! Now I think of it the last run of SWA I pulled in ended up about 6m short on a short run of about 50m. The digger...
  11. Resu

    Help pricing storage heater job

    Quantums aren't the worst to fit. The 24h supplies required range from 400w-1300w (due to booster elements). The biggest (QM150) is a 2 man lift. If you're serious about the distance then I'd say a sack barrow or even a wheel barrow is essential as you're talking probably 30 packs of bricks (and...
  12. Resu

    Oldest domestic dimmer switch

    I've got to remove a couple of those soon from a commercial property, unsure if they still work as the switch wires have long been removed!
  13. Resu

    Aico 3000 series smoke alarms,audio link.

    I think the OP means using the Ei168RC wireless bases instead of the Ei3000MRF modules.
  14. Resu

    Cable for connecting induction hob

    We generally use 4mm or 6mm HO7 if the oven/hob isn't supplied with it's own flex. Harder to get hold of the Italian spec stuff for the sake of ~5 degrees. That said my own cooker is connected with a bit of 6mm T&E!
  15. Resu

    Cable for connecting induction hob

    CEF website has 4mm HO7 for about £3/m including VAT. https://www.cef.co.uk/catalogue/products/2015171-4mm-3-core-ho7rnf-rubber-flexible-cable-cut-length-sold-by-the-mtr
  16. Resu

    Storage heater fault

    What size was the heater/how many elements? 23 ohms would be about right for a 2.5kW
  17. Resu

    Bulb placed into special administration - What now?

    I've been with bulb for years, on their vari-fair tariff which has served me pretty well before now. Referrals have been good too. Currently on 20.82p/kWh & 27.38p standing charge. Gonna stick just now and see what happens.
  18. Resu

    Why ring circuit on 32amp??

    Yes but in upping the breaker size you'd be lowering the max permissible Zs which may put you the wrong side of 0.4s disconnection time.

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top