It's a worcester combi boiler with heating / hot water connected to the low rate economy 7. There is a nest thermostat controlling the temperature. The issue is that the heating is not very controllable.
Should I get the boiler moved from low-rate ecomomy 7 to the high rate so it will be...
Hi people, I’m new to the forum, first post so here goes.
I’m wiring a heating control system and at the moment the customer wants as follows;
A JG underfloor heating system, this will be controlled by wireless thermostats, there is a 2 port valve and a wiring centre for the underfloor heating...
Hi.
We are looking at installing a Wiser smart heating system inc. trvs
We are currently electric only, with normal rads and a Heatrae sadia electromax combi boiler doing hot water and central heating duties.
Control is via a danfoss tp5000 battery programmable thermostat. This is only a two...
Hi, the circuit is pretty simple however shouldn't the boiler also have a permeant feed for the hot water as terminal 3 is the switch line for central heating?
Hello,
I'm hoping someone can help. I've been told I have to do a electric boiler service and I honesty have no idea where to even start.
I made my feelings clear about it, but it's unsurprisingly fell on deaf ears.
Is this something that I should even be doing (only lv3 & 18th qual) first, and...
Hello all
Looking for some electrical advice if possible. We had a boiler and complete new central heating system installed in our house 3 years ago. This has been working fine until recently when we had a new consumer unit with rcd protection installed to upgrade.
From the day this was...
What is everyone's opinion on taking a combi boiler supply off the lighting circuit? I doubt the boiler would pull more than 300 watts and with all the led lamps being used on the lighting circuit,I doubt it would come to more than a couple of hundred watts.A 3 amp fuse in the boiler spur would...
Hi everyone…I have a quick query regarding an issue I’m having with my boiler at home. There has been no hot water, the electrician has come out and diagnosed that the supply from the main fuse board has blown the clock and fuse spur. They also found that the cable is a flex cable and not the...
I'm sure this question has been asked to death, so apologies! But just wanted some direct confirmation that my intended wiring setup is going to be completely fine/not fine.
I'm currently planning on having my combi boiler relocated to a kitchen cupboard prior to a kitchen remodel. There is...
I am renovating a 2 bedroom flat that currently has no central heating and will rent out. Looking to the future I understand electric is best option but confused as to whether I should go with a combi boiler and hot water radiators or Rointe stand alone electric radiators? I cannot find an...
Hi all.
My mum has just moved into a flat and it has an electric central heating boiler and a hot water tank/immersion heater for the hot water. I’ve said will look into putting a combi boiler in to free up the space in the cupboard for a washer/dryer.
The flat is about 10 years old. The boiler...
Got called to look at a Gabarron CMX15 that was dead, discovered the Safety Limiter device on the CH side had tripped, reset it and bled the radiators are recharged to 1.5bar per the manual. long story short it has tripped a couple of times since. Done it today while I was there after only being...
Hello there!
Could anybody help me with this query please, I am not sure where to look up the information I need?
As I understand it, cables must be at least 25mm from an actual boiler or gas pipe? But could anyone please point me in the direction of any information regarding any regulations...
Hello
I have a Heatrae Sadia Electromax 9kW electric boiler that does hot water and central heating.
Recently it broke and someone from Baxi came to fix it (side note, if anyone knows anyone other than Baxi who will work on this boiler then please let me know, they seem really pricey). They...
A combi boiler is wired into a plug, which is plugged into a single socket. The Nest receiver, controlling the heating (heat link I think they call it), is wired into a separate plug, which is plugged into a socket on another circuit.
So 2 circuits interlinked, a minimum C2.
However, could...
I would like some advice please.
A friend of mine has moved into a small flat. There is no Gas supply to the property and so is looking into having a 14Kw Boiler installed. This would require a 63A breaker on the board. My calculations for Maximum Demand based on the other circuits in the...
Just had a call from an M&E client of mine and good mate asking to pick my brains.... large 3ph biomass boiler with (I assume variable speed) 1ph fans internally. Says he's got 230v L-N/E on the connecting plug but when the fan gets connected there's nothing on the internal fan connections...
So iv got to add a mini one UFH zone to an existing property's heating system, i have already wired in all the easy parts ie. actuator, zone valve, stat etc. however i just need to hook it up to trigger the boiler. iv attached a few images to try and explain things better, the plumber told me...
Hi guys,
My parents have just moved into a new build with an ideal S24 boiler.
They were complaining that the boiler was firing up randomly so I took a look.
I have completely re wired everything correctly (20 years experience, approved contractor) yet it still runs almost all the time.
It’s...
Hi All,
I wondered if someone might advise me on an issue I am having.
I turned off my power to replace a plug socket in my house and when I turned the power back on, the burglar alarm started going off. Unfortunately I have just bought and moved into the house and I do not know the codes...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc