driver | Page 5

driver

  1. B

    Led dimmer panel driver wiring

    Hi aver1 Need help pls I'm trying to wire led dimmer light 600x200 with a led driver and led dimmer switch Do I need permanently supply and separate switch wire to the led driver Pls help
  2. Dean Theobald

    Dimmable Driver With 240v Output!!!

    Hi everyone!!! I need some help. I’m looking for a dimmable 1-10v driver with a 240v input and 240v output. Can anyone point me in the right direction. Many Thanks
  3. Gavin John Hyde

    Long screw driver fittings for impact driver

    Im looking for a decent but not over priced set of the extra long impact driver bits, have had 2 sets now and both been a pile of s**t.. 1st lot arrived in small plastic bag and the metal was brittle and rough as hell... one snapped during use! the second set were so soft after just a dozen...
  4. HappyHippyDad

    Which LED driver would I require for downlights?

    Hello everyone.. I have a customer who has 5 x 12v downlight fittings that they want installing. I have explained that 230V GU10's would be much better but they are adamant they want these specific MR16 holders. I have replaced LED drivers before but never actually installed from scratch...
  5. M

    LED driver replacement advice

    Morning! Im wondering if anyone can offer me some advice relating to a John Lewis Cormack light fitting with a faulty Hytec LED driver (pic attached). I've tried replacing with a similar 24v 24w LED driver...
  6. telectrix

    LED Driver. unusual output voltage.

    as pic. anyone know where I can source this? 60 -90V output.
  7. curly

    Wiha driver set down to £15

    Hi guys I was in Screwfix this morning and they had a sign up for a set of wiha drivers that were going down to £15 tomorrow, I believe it is the set I am posting linking to below but it may be a different one. Anyway it's a good brand at a decent price Wiha SoftFinish VDE Screwdriver Set 7...
  8. J

    LED Driver Replacement Problem

    Hi Guys. After a bit of advise. My Costco outdoor led tree power supply went in to kill mode and was out putting around 100 vac instead of the designed 24vdc. The original was a 600mA 25 volt 36watt transformer -well that's what was on the label- Anyway I ordered a replacement driver - a...
  9. V

    Adopting PWM driver to microstep the motor for Raspberry Pi

    I have a project that uses a stepper motor (200 steps/rev, bipolar, 2A/phase). Right now I am using a chopper driver (that uses PWM as I understand it) to limit the current to 2A using 12VDC as the supply. However the motor is being controlled by the pi, with a python script sequencing the...
  10. Dannyg8810

    Torque VDE driver sets.........

    Going to treat myself tomorrow to torque interchangeable blade set tomorrow Anyone used any and recommend a certain brand?? Been looking at this Armeg 5 Piece VDE Torque Screwdriver Set | Armeg Screwdriver Set -...
  11. gazdkw82

    Good drill and driver

    I'm looking at replacing my ryobi drill and driver for something more professional/better quality and durable. I'm looking at brushless and ideally a drill and driver combi but happy with just the right drill for now. Iv looked at some of the makita ones and some of the Milwaukee ones but...
  12. Soulsurfer

    Small LED driver to find ?

    Long story short, builder I do a fair bit for, in a rush tried fitting some customers light fittings ! Prob caused a dead short and has said breaker tripped but also a pop from luminaire ! Sent me a pic of LED driver that he said had back blown off it ! It seems lower rating than most and I...
  13. J

    Would you give up being a train driver to be an electrician?

    As title says, what's the life of an electrician like, money, work load etc
  14. D

    Which driver for this downlight?

    Hi all, I hope you're well! I managed to get the attached downlight cheap from IKEA. I didn't realise the led transformer and leads were so expensive as I only need one of these lights. I've taken a picture of the label showing the specs. Is there a simple LED driver I can safely connect this...
  15. Lou

    Driver Electrical Services

    Driver Electrical Services have been trading since 2003, but director Neil Driver has been carrying out electrical contracting work locally since 1989, and has over twenty years experience as a qualified electrician. Lorraine Driver takes care of all of the administration requirements and...
  16. J

    LED Strip lighting behind bed frame.

    Hi everyone, I'm looking to put some LED strip lighting behind my bed (after redecorating). I have installed some warm white downlights in ceiling but want a small amount of mood lighting. The strip light is coming from a fused spur, into the driver and then to the strip light. The only...
  17. Meg464

    Transformer in LED light fitting not working

    Someone is asked me to have a look at a transformer in an LED fitting they have checked that it is not the fitting itself but they think it's definitely the Transformer inside it, does anyone have any thoughts or ideas about the best thing to do or how to fix the transformer or would it be best...
  18. M

    impact drill

    looking to buy an impact drill, whats the best make/model ? and does anybody know any places doing good deals on them
  19. J

    Converting Floor Lamp Halogen to LED - Advice

    Hi, Could someone please be able to give me some advice and electrical theory about converting a light from halogen to LED. The current circuit has 5 20W halogen bulbs running off a dimmer: Buy Bella 5 Light Floor Lamp from the Next UK online shop - http://www.next.co.uk/g503008s1 I have read...
  20. Dan

    Free Festool Battery!

    Festool 574759 T18+3 Li 5,2 Set Gb 18v Drill Driver 2 X 5.2ah Airstream Li-ion Batteries Supplied In T-loc Case - https://www.angliatoolcentre.co.uk/festool-574759-t18-plus-3-li-52-set-gb-18v-drill-driver-2-x-5-2ah-airstream-li-ion-batteries-supplied-in-t-loc-case-pid45039.html But then...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top