First year apprentice here, want to put a non maintained emergency light in where the consumer unit is going onto the lighting circuit for the new kitchen we’re doing with a switch too, would I do this by coming from breaker to emergency light fitting as this is the closest with L-N-E then out...
Hi, here's a good one - replaced 15 E-lights recently, (tube type replaced with Newlec led type), and noticed one of the old outside Thorn 2D E-lights was on when driving past a few days later. The Thorn lights are all up to spec and function as they should. Went to investigate and it seems that...
Evening all,
As you can see from the title I have not had a good day.
For the second time in my 6 year career I made a small nick in a water pipe whilst taking up the floorboards (using multitool). i thought i was prepared from the last time as I bought some clamps. However, they could not fit...
Today I've been working with an old emergency bulkhead with 26W 2D 4 pin, and 6W florescent tube.
When I replaced the 2D bulb, only a faint light could be seen coming from it. I assumed because there had been some physical damage to the fitting, that a component inside was bad.
As I went to...
Hi,
Quick Q from a newbie. I had a NICIEC registered electrician install an isolation switch and extractor fan in my downstairs bathroom. I’m now replacing one of the down lights and found what is a surprising mess of wires in the false ceiling, all joined together with a terminal block (centre...
Hello,
I'm hoping someone can help with a bit of an urgent situation I'm in! I've just opened a new bar/restaurant after a lengthy refurb. Previously, the venue ran of a single-phase meter.
The refurbishments have been extensive and with all the equipment we've installed (ventilation, air...
Hi All,
Long story short, I am building a plastic shredder with a 3 phase 3 HP motor. I am using this switch to control forward and backwards: https://goo.gl/k8zSxA (amazon). I need a switch or button that can cut power to the device. It does not need to stop immediately. I am not using a...
hi guys
For any of you that carry out periodic emergency light testing on HMOs.
I have read through bs5266 but want to get your perspective on these issues and if you would fail the system
There are non maintained emergency lights fitted to each floor and landing so the siting of the lighting...
Hi all,
A client has kindly changed their mind on the emergency light they are using. They want to me to install these
https://www.channelsafety.co.uk/emergency-lighting/all-led-downlight-products/glade-1w-led-downlight/
I’ve used these quite a lot and I’m most casss they are a good job, I...
hi all,
Can anyone provide a worked example of rating a breaker for a circuit.
For example
In an industrial environment, we have our own HV supply and each substation on site has its own earth rod. I assume this falls in to a TT system.
if I wired (14) 8watt lights in parallel back to a...
Hey all
I am a 17th edition sparky... but currently not actually doing much electrical work.
I work with a CCTV company that basically do as they please when it comes to regs, doing a job properly etc.
They have asked me to go test all the emergency lighting in a public building, and I...
Attending a job the other day in a shop. The shop is 20m long and 10m wide. There is an office/store/kitchen at the back leading to a communal store and passageway for four shops. Each unit locks its own door to this communal area.
The fire officer has told the owner there is no need for any...
I've come across a fault at work. Fuse keeps blowing when they put it in. I haven't tested for a while, and so am pretty sure I'm missing some basic steps with the fault finding process.
Small room. 1 emergency fluorescent light fitting, 1 bulkhead emergency fitting.
Fluorescent is plugged into...
Evening all.
Been a while since I made a post on here.
Question:
What is the title regulations/Acop that cover emergency lighting? - Concerning: Selection, erection, lux levels, where one is deemed needed etc.
And are such regs readily available to view online in pdf, or is a specific...
Hi all,
I was changing an emergency light fitting (maintained) and came accross an unusual wiring configuration. There were 2 supplies, 1x 4 core from emergency light socket and 1x 3 core from general light socket. There were 5 terminals inside the light fitting marked, T, L1, L2, N, E. The...
Hello
There is a high racking area in a warehouse with 12 aisles of 120m long each which needs the emergency lights upgraded.There are only a few twin head ones at the moment.I have been offerred new light fittings with integrated emergency backup( the cost would be obviously high).What would...
Hi,
The ladies toilet where I work had three lights off last week. I replaced the lamps in each fitting and two work but the last one didn't. It is an emergency light and is the last light on the circuit if that helps. I looked above the ceiling and they are all individually plugged in to a...
Hi all i was hoping for some advice, I am carrying out an annual emergency lighting test tomorrow in a hotel. Part of the hotel is no longer in use and all supplies have been locked off. Should this part of the building still have emergency lighting in place in case emergency services need access ?
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc