Hi
I need to create a fused spur with the connection into the RFC cable under the floorboards i.e. not accessible. Going with the regs crimps can be used as they are MF but is it acceptable to have three cables in each crimp?
Thats my post cherry popped! Cheers for your help.
James
I have a project where I need to take a (fused) mains supply for an HVAC control box (in a village hall) without disturbing decor. The obvious answer would be to replace a 2G 13A socket (double backbox) with a combined double unit (or modular units fitting into a double faceplate) that provided...
JohnGeddes
Thread
aus
damage
double
electricians' talk
existing
fuse
fusedfusedspur
socket
spur
Hi
Just installed two outdoor 2 pir lights on my boss house.
Ive spured off the downstairs ringmain 2.5 twin to the spur and 1.5 flex out to the light.
I was told that the right side of the double socket was not working after installing, the right hand side of the socket showed a slight burn...
Nocker
Thread
aus
between
cable
electricians' talk
fuse
fusedfusedspur
problems
socket
spur
tester
voltage
I have installed eight LED garden lights (5.4w) and a couple of PIR lights (400w total) via a Fused Spur (5amp).
When the lights are turned on via the FS the socket circuit MCB trips (RCD is ok). MCB can be flipped on and stays on.
Wiring looks good.
Any ideas ?
Thanks.
Can anyone tell me if there is a reg for fitting a fused spur in a toilet cubicle for a saniflow pumped toilet ?
i.e is the minimum distance going to be 300mm ?
sg spark
Thread
aus
electricians' talk
fuse
fusedfusedspur
special
spur
toilet
Hi, I'm installing an outdoor light and am going to spur off a socket ring circuit, I was going to spur off a socket that was closest to where the installation is going up, but have realised that there is a spur coming off the socket outlet. Is it possible the have two spurs coming off the same...
My old man just rang me wants to buy a welder but the manufacturers instructions say the welder has to be connected to a 30A fused spur, He hasnt bought it yet he said hes going to get more details for me tomorrow which ill post up,
From what i gather this'll have to be on a dedicated circuit...
hi i live in uk and bought a 160a arc welder and itsays i need to connect it to 230v 30amp fused spur but all sockets at my house are 13amp 230v so how can i use welder and what socket do i need and how can i use it or make a 30a fused spur?
Am I going mad??? can you fit a switched fuse spur in the bathroom outside zone? its for a boiler and will be enclosed within the boiler cupboard which i know meets the regs but I cant find any reason in the regs that says it has to be enclosed (within boiler cupboard). Oh the installation is...
Ombos
Thread
aus
electricians' talk
fuse
fusedfusedspur
outside
spur
switch
switched
zone
Hello,
I currently fit CCTV and I'm looking for a course in the birmingham area ideally in the evening or weekend were I can learn to legally fit a fused spur to conform with Part P reg's looking on line it looks like I have to pass power wiring level C if someone can confirm if this is right...
m1ke
Thread
circuit
electricians' talk
fitting
fuse
fusedfusedspur
issue
part
part p
registered
scheme
special
spur
Visited an installation today(new build) and in the shower room there is switch fused spur 1200mm from shower cabinet so outside zone, with it not been a socket according to the OSG i see this as ok.
The problem I have is with the heater, it’s a convertor type heater mounted that the top of...
fascally 07
Thread
aus
electricians' talk
fuse
fusedfusedspur
heater
room
shower
spur
switch
Hi,
I'm to install an extracter fan with a timer in a a brand new shower room. I got a question.
I also bought a 6A 3 pole fan isolator from Crabtree, it included instructions with diagrams on how to wire up a timed fan, to my dismay the diagram did not include a fused spur as it was coming from...
Maddermanblue
Thread
aus
diagram
electricians' talk
fan
fuse
fusedfusedspur
light
spur
switch
Hi Everyone
First post so don't be to harsh on me.
Have a 13A neon fused spur for a dishwasher put in by a spark in 2.5mm.
The dishwasher is an old mela variety with a cold feed.
The neon area around the switch, the load outlet is also behind it is becoming quite warm in operation and then...
Can anyone confirm or deny that the fused spur used to isolate the boiler and all associated controls has to be local to the boiler. It makes sense that it should be, but I haven't seen it specified on any of the wiring schematics. All the schematics that I have found still suggest that the...
A customer has a RCD spur unit spurred off a ring supplying their garage. It is all wired in 2.5mm twin, and in the garage there is only two sockets with nothing plugged in.
The RCD spur unit would not reset so have replaced with an identical one. When the power was turned back on...
lim88
Thread
aus
electricians' talk
fault
fuse
fusedfusedspur
rcd
spur
unit
Hi,
The builders are extending the kitchen in my house at the moment which means putting in an extra 2 double sockets. I'm doing the electrics myself. I plan to to fix an unswitched 13A FCU to the spur off the ring main and put the 2 new double sockets on it.
I have been looking at the big red...
Maddermanblue
Thread
cable
cable size
electricians' talk
fuse
fusedfusedspur
main
off
question
ring
ring main
size
sockets
spur
Hi guys, can anyone point to the building reg about appliances in the kitchen having a seperate switching, e.g washing machine under a worktop- socket under the worktop supplied from fused spur above. Thanks.
Going to install some decking lights. The fuse board is old school re-wireable fuses - no RCD protection. The owner doesn't want a consumer unit change (yet).
My plan is install an RCD protected fused spur from the kitchen ring main.
The ring itself won't be RCD protected but the spur...
Im changing my current 13A fused spur with a new one which is spured off the kitchen ring. the fused spur is spured off a double socket. There are 2 2.5mm2 cables with 2 red and 2 black and 2 earth wires. the flex which powers the boiler has 1 blue, 1 brown and 1 earth wires. I took note of the...
Hi all,
As ever, I prefer to check with others before proceeding with work I've not yet encountered, however I'm pretty sure I'm ok with this one.
The lady i'm helping is having a new gas top hob to replace her old one, however the company who are installing the oven/hob refused to wire...
Tasty
Thread
aus
cable
electricians' talk
fuse
fusedfusedspur
however
kitchen
outlet
socket
spur
under
units
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc