outdoor | Page 7

outdoor

  1. M

    UK Advice on outdoor circuit please

    Hi All, Appreciate some advice on an outdoor socket and lighting circuit please. I currently have an outdoor socket on my house, that i believe to be a spur from a 32A ring. I would like to extend this out to decking for some lights and sockets, and onward to a shed for a couple of lights and...
  2. O

    Outdoor Outlet Placement/Install

    Hello, We are making changes to our backyard and needed to move an existing 2 gang outlet. We have existing outlet at the other end of the yard. We are wiring the existing outlet to the 2 gang outlet, but need help on where to mount the 2 gang. As you can see from the attached pictures, we...
  3. G

    Outdoor Circuit?

    Firstly, please excuse the volume of posts. I’m finally getting round to all the jobs I’ve been promising the wife for in some cases years. i purchased a Knightsbridge IP663g outdoor switching box with the idea to run 2 small lighting circuits in my Bbq area approx 15 m from the house. The...
  4. J

    outdoor light cable

    Hi i had an seperate circuit put around the house for outside wall lights with its own mcb. I told him where i wanted to eventually fit the lights (wall lanterns around 3 meter of ground level) he drilled the holes for the cable to pass through to the outside on each light location and also ran...
  5. naylorpd

    Connector for outdoor floodlight

    I have some outdoor floodlights at home in Azerbaijan, which need replacing. The way they are connected is in the photos - cable through the stone base then up into a waterproof box through a gland. The problem is that the newer model floodlights that I can buy have much shorter cables -...
  6. M

    Installing outdoor socket

    Hi My aim is to have an outdoor socket sited near a new garden structure approximately 5 metres from the back of the house. SWA will be used for the entire run. I have an existing external socket (IP66 without RCD) on the back of my house fitted by an electrician during a kitchen refit. It is...
  7. N

    Adding outdoor light to existing circuit

    Hi, I simply want to add an outside light to an existing circuit in the garage. There is a single switch operating a ceiling light in the garage, would it be ok to change the single switch to a double switch to connect the outside light or is there a better way of doing that? Please let me...
  8. J

    Outdoor lighting pir

    Hi, I recently replaced one of three outdoor pir lights which worked fine. today I installed the second one, which didn’t go so well. It’s not working and now neither is the first one I installed. does anyone have an idea of what could cause this? I am by no means an electrician and my...
  9. S

    Timed outdoor socket supply

    Hi I’ve got a standard double outdoor socket that has been installed for some time, and I’d like to make the supply to it timed to run some lights in the garden in autumn/winter only. I’m planning on using a greenbrook mechanical timer, which is rated at 16a resistive and 2a inductive. I will...
  10. S

    Need help with outdoor speakers and amp

    Hey guys, I need your help. I bought the following 4 speakers, amp and selector switch: https://www.amazon.com/dp/B010U5EGKE/ref=cm_sw_r_cp_api_i_T9FODbSWNDB8J https://www.amazon.com/dp/B000A5S926?ref=ppx_pop_mob_ap_share https://www.amazon.com/dp/B07NPZM489?ref=ppx_pop_mob_ap_share I had...
  11. J

    Outdoor TV antenna grounding question

    Ok Hello all and thanks for having me. I need some advice and joined this forum hoping to be pointed in the right direction. First off I am not an electrician and dont know the first thing about grounding or wiring. I will try to explain it the best I can. I recently moved to Middle Tennessee...
  12. Bob Geldoff1234

    Help with outdoor waterproof boxes

    Can anyone recommend a type of sealant that i can fill a plastic box with to totally insulate the connections from water and damp.A bit similar principle to swa joints where you fill the whole plastic joint up with some sort of compound. I need to fill 10 outdoor boxes approx 3"x3" and 1" deep.
  13. S

    Outdoor lighting install

    Hi everyone, first post and novice DIY currently installing outdoor lamps. Had new extension built, builders have left twin and earth cables taped off at the ends. All except in one position where it's looped back into the wall (see pic). Directly behind the wall on the inside is the three way...
  14. P

    How do I mount an outdoor electrical box to line in mast?

    see pics (Please enter a message with more than 3 words )
  15. Ashley-Joseph

    Outdoor socket

    If I install an outdoor socket does it have to be notified to the local authority and can I test it with a multimeter with out opening the cu ?
  16. H

    UK Outdoor LED Floodlight

    Hi guys, I've put up a LED floodlight bought from Costco twice now. It replaced a old halogen type floodlight that was already wired in. Both times it has worked fine for about the first 3 days. After this both times the PIR sensor has stopped working, so when there is power to the light it...
  17. Y

    UK Outdoor Consumer Unit

    Hi all, I'm looking for advice on fitting an outdoor consumer unit, which will be run from the consumer unit in my house.(1)(2) I am then installing an outdoor socket (2) from the outdoor CU and also running cable to my shed (1)(2), where I will be fitting another CU - to run a light and double...
  18. Midwest

    Opinions on outdoor socket

    I’m building a man cave/BBQ area. It has a substantial roof, a weather proof back wall, but open to the elements on the other three sides. It’s large enough so the back wall won’t be susceptible to rain etc. In the rest of the garden, I’ve used MK Masterseal sockets. However, they are a bit of...
  19. Henry_

    Outdoor socket used as junction box

    Hi, I am currently building a new outbuilding in my garden to be used as an office which will end up having a reasonable amount of power usage (Heating, multiple computers, lighting and a few other bits and bobs) and I am looking at reusing a power feed that previously ran to a shed which was...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top