Hi all,
Pricing for a supply to a 25x 10M steel frame shed around 100M from a bungalow, one section is going to be partitioned to create a stable area.
Is there any requirement for a 300ma S type RCD?, I wouldn’t really class it as agriculture. Only 2 double sockets well away from the stable...
Hi all,
After some advise.
I have recently built a retaining wall with steps out of concrete blocks laid flat. Around 700mm tall
The wall will hold back around 500mm or so of ground, leaving a nice 180mm ish of wall above ground level.
My plan is to install lights ( brick lights I assume )...
Hi all,
Trying to wire in some lights in the garden in multiple positions but all activated by one microwave sensor at the top of the garden.
I cannot wire the lights straight to the sensor as landscaping ECT and I do not want them on independent sensors either.
So I'm looking for a transmitor...
Hello,
I am new to this forum- is my first time posting so I'd like say hi to everyone.
Im stuck with extending an outdoor socket, so I need help please.
I currently have working duo ( socket and switch) outside my home. I want to extend it to a ne2 oitdoor socket few metres away
I ha e...
Hi
I am a landscaper and I am looking for a S*** hot electrician I can call on to carryout landscape lighting quotations to run alongside our works. Obviously take on the works when contracts come in (some of these contracts do not start for 6 months after quotation issued)
We are in Harrow...
I'm installing some outdoor lighting (in my garden). Run some swa to Wiska boxes. I intend to go from there with some TRS flex close to each light. The lights I've have are sealed, with 1.5m of flex, so I will have to extend the flexes. Was going to use some small Wiska boxes etc to do this, but...
Hello, would appreciate a steer please for extending power further into the garden. Fuse box has a dedicated fuse (see pic) for Garden providing 16amp. Had an electrician that has previously connected armoured cable from existing double socket in garage into new shed providing a double socket...
Hi Guys,
Please can I have some advice on IP67 switches. I would like to use outside to replace bulky plastic switch boxes available on the market. One will be used for a light switch and another for a door bell. I plan to use a stainless steel push switch mounted on the face of a small sealed...
I'm doing my garden in me new build; well I'm paying someone to do the hard it 'landscaping' (it ain't that big).
Obviously I'm gonna do my little bit and add some lighting. When someone else has asked for lighting products, I've always said try Collingwood Lighting.
Now I always knew they...
I am looking to install lights in my garden. The cable will be run from the garage from the main fuse box. I want to be able to switch the lights on and off without having to go into the garage. I was thinking of maybe Bluetooth via mobile or a remote.
Can you give me some advise on the best...
Hi there,
i currently have a outdoor light that comes on only when i flick the switch.
i would like to install a motion sensor light instead.
my question is can i use the existing wiring setup and switch, and just keep the switch in the on position so the light will come on when it senses...
Hi folks,
I wonder if someone could enlighten me as to whether or not I could install an outdoor double RCD socket and wire it to a a pre existing internal switch?
The switch itself would have been intended to be connected to an outdoor PIR and its in a new build house. The switch is wired...
Hello,
I have two almost identical circuits of outdoor 12v lighting setup in my garden, each running off a separate 20W 240v-12v transformers (12v Waterproof Transformer (Various Wattages) | 240v - 12v | 10W - 150W -...
Hi
We are having a new log cabin installed at my work place and after some advice. Will be getting electrician to come and quote etc but would like to know what it entails first if possible.
Currently we have one cabin (with lights, sockets, heater) this is fed via a 2 way garage DB - 40A, 63A...
Hi I need some advice/help as complete Novice. I have just purchased a new build and on this i have an outside light that is powered by a switch indoors. However I would like to install a flood light above it using the power that is supplying the existing light. There is a power block on the...
Hi guys, quick introduction, I am only qualified as a domestic installer, not a full sparky. My company builds bespoke garden rooms. We have been asked to supply an outdoor dining room for a client and they are extremely keen on having the consumer unit and under floor heating controls on the...
Hi there. I just bought this outdoor security camera kit from Amazon.
https://www.amazon.co.uk/gp/product/B00WLJ38DO/ref=oh_aui_detailpage_o09_s01?ie=UTF8&psc=1
When wiring it up, I noticed that I got a small sharp shock when touching the small screws on the metal casing around the cameras. I...
Hi guys,
I'm recently qualified so naturally a bit hesitant on my first jobs so looking for advice as much as possible.
I'm working as a junior at a domestic job where the customer has a large garage which has a sub main (run from the main unit in the house via SWA) consumer unit in it...
Hi All,
I have an Halogen Floodlight wired to a 20A JB situated on an external wall with no IP4X protection. I intend on ripping it out and rewiring it and replacing the floodlight with an LED alternative.
However the issue I am having right now is regarding the cable.
I planned on using...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc