point

  1. J

    phone and tv in new builds

    evening guys to the guys that do new builds blocks.... what do you usually do in regards to tv and phone points? got drawings for a 4 storey block that house 7 units (4 flats and 3 duplexes) with common areas on each floor
    • J.C.E
    • Thread
    • builds new new builds other phone point position property
    • Replies: 17
    • Forum: UK Electrical Forum
  2. C

    Car Chargers

    Hello guys I have a car charger installation coming up and will be installed as per the below. TN-S supply to building 35mm thermosetting main tails supply existing 3 phase DB. X 5 chargers to be supplied by by 4mm SWA cabling on tray protected by a 32a 30ma RCCBO. the chargers are located...
  3. V

    What determines your rates?

    Hi, what determines an electricians rates, living in London. What points would you say distinguishes those earning £25/hour and those earning £50/hour?
    • voltvoltvolt
    • Thread
    • domestic having market point rates
    • Replies: 14
    • Forum: UK Electrical Forum
  4. Pete999

    Pete's Videos Old and New work boxes

    Wonder what the Staff at your local CEF would make of a request for some "Old work boxes" and some "New work boxes" confusion would ensue.
  5. gazdkw82

    SWA building entry point

    got myself a new timber workshop. The previous workshop already had supply via SWA from house CU. Iv got new cu for the workshop and appropriate gland kit however I'm unsure what's best practice in terms of getting the SWA into the workshop. Is it just literally a case of drilling...
  6. R

    How to gain qualifications to install charge points

    Hi all. Looking to install EV charger points mainly on domestic properties does anyone have info on any courses and how I could become a registered installer with gov. On gov.uk it states to receive a grant to install a point a house hold would need a registered sparks. Looking further gov.uk...
    • Robinson
    • Thread
    • charge how to install point points qualifications registered states
    • Replies: 2
    • Forum: UK Electrical Forum
  7. 1

    eicr

    Hi guys R1+R2 on a eicr mates tutor on the 2395 course said no need to carry out just zs is enough and on ring just end to end readings what's everyone's thoughts on this
  8. HappyHippyDad

    Changing the LNB on a satellite dish or splitting the cable?

    Hello all. As part of an extension the client has asked for another TV point. The present TV point is run from a satellite dish which has a sinle LNB on it. My question is, is it ok to split this cable? I'm guessing not as you may not be able to watch seperate channels on the TV's from the...
  9. M

    Identifying single core cpc's and neutrals

    Just wondering if anyone has any handy tips when trying to identify single core cpc's and neutrals? I work in a few food factories than are in constant production and switching off supplies is not an option, so identifying circuits can get pretty tricky. Identifying neutrals is pretty simple...
  10. Pete999

    Pete's Videos Say it like it is Mate

  11. O

    Dual colour warning labels

    So do you stick them on CU? Are they necessary? Are they a waste of time and materials. Cards on the table - I think we should boycott them completely!
    • Octopus
    • Thread
    • colour label labels point warning
    • Replies: 57
    • Forum: UK Electrical Forum
  12. A

    Does this pricing for kitchen sound right? Jobs in London

    Does this pricing sound right for a kitchen rewire London 8 spot lights x £60 point 1 heat detector £70 outside lights x 3 £210 oven 6mm supply £200 hob supply 6mm £200 fridge freezer supply £60 dishwasher supply £60 extractor supply £60 5 double sockets £480 aerial point with only means...
    • Abruno
    • Thread
    • consumer electrical work electricians london in london jobs kitchen london point pricing right sockets sound supply
    • Replies: 13
    • Forum: UK Electrical Forum
  13. Dave301

    Main Bonding

    House has had gas installed. Meter is outside of property at front. The box is not attached to the building and the gas pipe enters the property under the floorboards. The pipework goes to the boiler at the rear of the property under the floor the whole way. Is it OK to put a bonding clamp...
  14. bartkusal

    Gas bonding comercial

    Hi everyone, Wasn’t here for a while, would like to get some opinions on my issue, if you don’t mind folks. Gas bonding issue, gas incoming pipe is at one point and it’s boded as soon as it enters the premises, the meter is about 20 meters inside the premises, I have my boss insisting that...
  15. haptism

    Earth marshalling point

    Hi all, have a question about an earth marshaling point. Just looked at a building where there is no bonding present at the incoming water stop cock (although a bond has been made somewhere, from a sub CU). If i put a clamp on the incoming water is it acceptable to run a cable to earth bar of a...
  16. D

    Do I need a Certificate

    Hi, I have a 6 gang grid plate, which has switches for my Fridge, Freezer and Dishwasher, and each has there own connection point around the kitchen for the respective appliance. I am wanting to move the connection point for the fridge about 150cm, and lower the freezer one about 20cm, and...
    • dunaldo
    • Thread
    • certificate connection point possible
    • Replies: 3
    • Forum: DIY Electrical Advice
  17. L

    BT wiring

    What's the preferred method for wiring telephone points? Is it best to Star/spider wire or loop in and out in a radial? which method does BT prefer? Is there any benefit of one over the other? Cheers
  18. T

    Can anyone estimate for this ?

    put in two ring circuits (18 D/so) and do dead tests, connect into consumer unit, do live tests A visual inspection of the lighting circuit with tests Dead and live and record loft with boxes and boarded (Lim) but some wiring in sight A risk assessement and method statement/Toolbox talk affix...
    • The Ghost
    • Thread
    • anyone boxes chase estimate point tests
    • Replies: 7
    • Forum: Business Related
  19. L

    DNO maintenance on 11KV line

    Something that's always confused me and never been explained to me is when the DNO work on a 11KV line they clamp the 3 phases togeather and spike to ground. Then further down the line they do the same. This creates an alternative path for the electric to travel (through the ground) making the...
  20. L

    EV Charging point installers

    I was just wondering if many folk are now involved with the installation of EV charging points? Demand in this area is obviously increasing. I'm very keen on green energy and I'm considering specialising in this area, is anyone else doing the same?
Best EV Chargers
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

Advert

YOUR Unread Posts

Advert

TrueNAS JBOD Storage Server

UK Tiling Forum | Tilers Forums
UK Tiling Forum by Tilers Forums UK
Plumbers Forums | Plumbing Advice | Gas Forum
Electrician Tips from Professional Electricians
JBOD Forums: a forum for JBOD storage server advice
JBOD Suppliers: JBOD Storage Server Supplies
Back
Top