shed

  1. cliffed

    External open metal shed

    Metal shed used for storage,it’s got no doors,like a porch effort. Swa enters the back of the shed,clipped to a commando socket,& used to supply equipment,does the shed require main,supplementary or no bonding.
  2. J

    Can I fit a plastic CU in a shed?

    Hi guys I’m installing power to a shed where there’s a good chance the roof leaks. I can fit an IP65 plastic weathertight CU in place of a metal clad one right? It’s going to be installed in the furthest corner from the entrance.
  3. B

    Wiring In a Shed, advice needed on SWA route

    Hi All, I have a couple of questions regarding running SWA cable between the Internal House CU and The Shed New CU. The shed is basically being used as a home office and as such has a 6A lighting circuit and 16A Circuit for Socket outlets. Will be running a couple of computers and Monitors...
  4. ELECNEWT

    SWA CLEATS IN WOODEN GARDEN SHED

    Is there any requirement or logic to using fire-retardant cable cleats for SWA inside a wooden shed? There will be a 2 metre vertical run and a 3 metre horizontal run of 4mm 3 core SWA.
  5. C

    house to shed getting 3core swa round bend of house.

    So I have a job to provide power to a cabin in a back garden.. Will be 3core 6mm SWA through back garden, consumer unit is at the front of the house, there is no way to dig the cable round to the back of the house as its a terraced house with a pathway to the back garden so will need to be run...
  6. FoxySparky

    Csa of cable for Outside shed CCU

    Lads and ladies! Clear up something for me please. The old man has asked me to provide some power for his outside wooden shed, by means of a CCU and breakers for the lighting and power. He will be running various power tools for fixing bits and pieces, and mowing the garden, while also having a...
  7. C

    Supply down to garden shed

    Small garden shed needs supply for x2 socket and a lights. Client does not want anything fancy like a fuse board due to light usage of garden lawn mowers Socket will only be used for lawn mowers. The supply will be taken from the existing ground floor ring, the SWA from the house to the shed...
  8. L

    Shed Supply on TNCS/PME

    Hi, I know this is a very commonly debated topic, but I have never found a solution agreed by a majority. I am in the process of building a wooden shed, approximately 20metres from the house (up to 30 metre cable run to the CU and meter cut out). I have a PME/TNCS supply to the property and no...
  9. P

    supply to a shed on a tns system

    Hi everyone I have a question I have been asked to look at a job this week and I am a bit puzzled. A chap I know has a shed connected to His down stairs ring to a garden shed via a 2 core swa cable. Its connected to the rear of a outside socket the armour of the swa is connected to the cpc at...
  10. K

    Some advice: Power to a shed

    Hi all. I’ve joined the site to ask for a quick bit of advice. Please note, I’m not an electrician, I will be hiring one to complete the bulk of the work required, but I would basically like to know what are my limits in terms of DIY. Not only is money tight, I also need to carry out some prep...
  11. driverman

    Shed supply from new build property

    Hi guys, as the title suggest. Friend of mine buying a brand new house from a reputable and well established builder. however it has already been 1st fixed. He\asked the builder if he could have an U/G supply taken out to the detached shed. Yes they could, no problem. Method. To tap off the...
  12. M

    lighting in the metal shed

    Hi, Need a word of advice, how should I run supply to two metal sheds that are located about 20m away from the main DB. Should I run in SWA with 10mm bonding and as separate circuit to each shed or through sub-board adjacent to them? What IPX of switch and lighting should be, I'm expecting some...
  13. diyterry

    Shed to shed which cable?

    Hello, I hope you're all keeping well. I'd like to replace the electrical cable which runs overhead for three metres between my two sheds, what type of cable should I use?
  14. T

    Earth rod needed for shed supply or pme allowed ????

    should you install a earth rod if running a feed to a shed which is built on timber frame and is all timber , no metal parts and will have no services ie gas or water in it so no need for bonding only a supply for a light and a couple of sockets or can you use a pme earth from fuseboard if the...
  15. Skyr4t

    Workshop (shed) power

    Hi all! thanks for the add :) I consider myself to be pretty competent with my wires. I completed the level 3 electrical building and structures course a few years back. Never progressed any further unfortunately due to health problems. But anyway I just need a bit of advice on a workshop I'm...
  16. M

    Garden lighting... PME from the house or TT from the shed?

    Expecting I'll have to put it on the TT but here's the situation... PME from the house connecting to the armour plus one core of outgoing SWA. Intending to terminate the SWA at a wiska box on back of the shed (outside), connect the armour to the cpc again and that earthing ends there (some...
  17. J

    New sub board for shed swa advice.

    Hi guys new to the forum after bit of advice. My family are installing a new shed in the garden and require a lot of power ie few sockets, lights. I am planning of running a swa fed from 32a mcb from the main board to a sub board. Have a question- Shall I install the new 32a mcb in the main...
  18. Daniel Oake

    Power to a shed. What are your thoughts?

    Iv'e come across a shed that was supplied via a 13A Fused connection unit with 2.5mm squared flat twin and earth on a 15 metre run inside 20mm plastic conduit that was clipped to their wooden fence every 300mm. Supplies 6 double sockets and one 5ft LED light fitting. (earthing arrangement is...
  19. R

    Electricity/Water and Broadband cable to shed

    Hi, I have got amour covered electricity and Broadband cable ready to be buried in the garden to run supply to my shed. And I am going to run water up there as well. My plumber said I need 25mm water MDPE pipe. So I thought it would be good to get threes times the amount and use as...
  20. C

    Power to garden shed

    I've looked around on here and have seen a lot of chat about this issue, but nothing that answers my specific question. I'm not an electrician, so rest assured (when the time is right) I will be calling one in. My question is this: Would it be acceptable to, rather than dig a trench to bury...
Best EV Chargers
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

TrueNAS JBOD Storage Server

YOUR Unread Posts

Daily, weekly or monthly email

Receive a daily, weekly, or monthly email containing a digest of new and recently updated threads.
UK Tiling Forum | Tilers Forums
UK Tiling Forum by Tilers Forums UK
Plumbers Forums | Plumbing Advice | Gas Forum
Electrician Tips from Professional Electricians
JBOD Forums: a forum for JBOD storage server advice
JBOD Suppliers: JBOD Storage Server Supplies
Back
Top