Hi Everyone, DIY advise required here please.
I have the following wall switch, currently wired in as below and controlling external roller blinds.
Inside the wall view has additional wires.
My DIY project is to replace the wall switch with a smart one below
And here is my wiring...
Please can anyone recommend a smart dimmer module for use with Aurora LED GU10s that remembers the dim setting on loss of power so that the lights don't come back on full brightness (or, even worse, remain off) when power is restored? Ideally Wi-Fi controlled. There isn't sufficient space in the...
Good Evening Everyone
Was looking to replace both my old Danfoss mechanical thermostats with a smart thermostat. Was wondering if anyone had recommendations for the following set-up (circuit is 240v).
There are 2 solenoids, one for upstairs and one for downstairs, and a thermostat each for...
Disclaimer: Not a pro sparky, so i have no intention of doing this myself, but I am looking for options that I can then take to someone qualified.
I am looking to replace the consumer unit in our house for a number of reasons, and its location means that it is directly visible by anyone coming...
I have outdoor lights that are controlled by dusk sensor and then timer (for OFF) on the right of the picture. The switch to the left of the box powers off the entire fusbox therefore I cannot change that as I have other things I keep on). What do I need to buy (switch/plug?) to swap the old...
Hello! I'm installing an Aqara smart light switch (with neutral) but nothing is powering on after getting everything wired up. I've attached pictures of the original switch (working) and the smart switch (not working). I've confirmed power was restored at the panel and voltage tester confirms...
Hey
So I'll say I'm not a qualified sparky however I know how to wire up a replacement socket or a replacement dimmer (but I couldn't add a new one)
I'm looking at Lightwave products for smart sockets with energy monitoring. Are these any good good? Would I perhaps need anything in addition...
Trying to install a smart thermostat,
I have 4 wires red, yellow, blue and earth,
And this smart meter wiring diagram baffles me.
1st photo old thermostat,
Hello, I am on Economy 7 and I have storage heaters and a hot water tank connected to a separate CU for my off-peak usage. The timer that switches to the off-peak circuit at night on my newly installed SMETS2 smart meter is wrong so I am being overcharged by 50% for my night appliances. The...
DIY Advice required. Ive just recently brought a Sonoff T0UK1C wifi smart switch for my Living Room. The existing light switch is ya standard one way switch with live/neutral connected (No earth wire connection - therefore earth is isolated). How would I wire the Sonoff switch in replacement of...
Hi DIYer here. I replaced a one gang switch with a no neutral smart switch. I put the provided capacitor between live and neutral in the ceiling rose. All seems fine except that occasionally the light flashes when one of the other switches on the loop is switched on. Is there anything I can do...
I have a 4 gang Deta Smart Switch installed that has replaced a standard (old fashioned) 4 gang switch that is used to control 4 air conditioning zone dampers.
The Deta switch responds to the wireless app commands turning on / off as commanded or of course when touched manually, however the zone...
Sorry for the long first post, I wanted to be as thorough as possible.
On my landing I have a 2-way switch setup, one of which is 3-gang, one of which is 1-gang, and I’m looking to replace them with smart switches. I’ve purchased a few BroadLink LC-1 switches based off the recommendations of...
Hello
I wonder if anyone could advice please.
We have only electric. We are not able to have a smart meter as there is anothe rcable required (too short or something) but EDF will not do it.
Years and years ago we used to have a smart meter thing before they were called smart meters! I used to...
The idea of having electrical power from 240volt AC sockets in a sectional building not on the national grid is becoming popular among those who want to live in a tiny house. Is it possible to connect somehow a used lithium ion battery from a Two seater Smart Car to an inverter? Then to connect...
Hi, I have a flat in a rather old building in London. Its subdivided into a few individual flats, and there is a meter board with a gas and electric meter in each flat. My electricity supplier sent someone out a few days ago to fit a smart meter, but the fitter said he was unable to do so...
I’m currently in the home-buying process, and some of the homes I’m looking at have Smart Meters installed. Thankfully, I live somewhere where we can easily opt-out and have an Analogue Meter installed by the utility company, so making that modification would not be too difficult. However, I’m...
Hi all,
I have a slightly mish-mash heating set up, in that downstairs I have wet underfloor heating with an individual thermostat per room, but upstairs it's a single thermostat for the entire floor with normal radiators with TRVs. I want to be able to control the temperature in each room...
Wireless Switching from Anywhere via a Smart device app
In addition to handheld remotes, would your end customer benefit from wireless switching devices via a Smartphone app?
Introducing the NEW RIoT Receiver:
A 4 Channel wireless control receiver
Switches outdoor lights, door/gate motors...
Hi
I have a double pole switch that switches on and off the outside lights under guttering area (front side and rear of the house all operated by this one switch). I see 2 Live cables in L1 and another red non-Live cable in L2 which becomes live when the switch is turned on. There are 2 black...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc