I currently have a 2 gang switch outside the bathroom - one for the light and one for the extractor:
I'd like to change the way it works slightly so that the extractor comes on if either the extractor switch is turned on or the light switch is turned on. I was wondering if anyone could offer...
Rather than pull a new line from the panel by busting through walls, I am tapping an existing line in our bedroom to add an outlet and switched light in the neighboring enclosed mechanical room. The problem is that the existing line is on a switch 15 feet away that controls the bedroom ceiling...
A lean to with a metal clad box and a plastic double switched socket fitted to it adjacent to a water drain for a washing machine. Obviously I am not happy with it so thought I would fit a BG weatherproof IP66 as a direct replacement; thinking I had to remove the flex I pulled some 2.5mm T&E...
Hi Good morning, i have just replaced 2 old dowlighters with LED ones, however, one is bright white and one is soft white(like a glow), the other problem is they swap over when switched on/off at the switch? any help greatly appreciated.
Hi all,
I recently bought and moved into a house and set about changing all the halogen bulbs with 4W non-dimmable LED bulbs. Upon doing so I discovered that when I switch the bathroom lights off at the wall, instead of going off they just become about half as bright as they are with the wall...
Domestic single phase supply, TNCS, 25mm tails.
From supply to Fused switched isolator : Earthing conductor is 16mm.
From isolator to CU : Earthing conductor downgraded to 6mm for what ever reason I don't know.
Is there something in the regs that says after an isolator the conductor can be...
Hi. I have an outside porch light which has a switch just inside the hallway. I am adding 2 more outside lights to be switched on using that same switch. I have ran 1mm cable from the switch line and neutral & earth to the new light and continued that to the 2nd new light. When I switch the...
Our toilet extractor has, or so I thought, been failing (delayed startup, bit intermittent) for some time, and yesterday it finally stopped working. Vent-Axia Silhouette 100T.
It's going to be a bit of a pain to replace, so I though I would check the connections first just in case. Imagine my...
I am as newbe DIY as it gets when it comes to electrical work.
Here is my issue at my home. I have a light switch which controls the recess lighting in the living room as well as all the plugs. A pretty poor design IMO especially since that room also acts as the TV/entertainment room. As of...
I wired 3 plate method loft light from supplying from my sisters bedroom light ceiling rose, the only way the loft light I fitted tuned on is if my sisters bedroom light was off, so then I it was really bugging me I went back to my connections supplying the loft light at my sisters ceiling rose...
I would like to know how to wire in a switch and outlet in my cabinet. Should I pigtail it after the GFCI? I would like to add a switch as well. Here is the wall, If I can utilize the outlet and add a switch here, wall access will be doable.
.
My original intent was to add a switched...
Hi all, I’ve changed a board and then some time later went back to replace a dimmer that had failed. I’ve got 17 fixed led down lights on a switch which I swapped out feed from a 6a on a split rcd with the induction job on the same rcd on its own 32a.
With the down lights on, switching on the...
Hello, we are in the process of trying to sell our flat, the buyer has had an electrical survey and the report stated that having 2 sockets without switches was against regulations. Is this true and if not can someone please point me in the direction of the standard that proves it is not true...
Hi. Hope I'm writing in the right place. Looking for some advice, before getting an electrician in. Warning a bit of a long story ahead. So we recently bought our very first house. An older building built in 1950s.At first everything seemed OK, and survey didn't pick up any problems with the...
One of these: RS/104 | Wylex 45A Fuse Switch Disconnector, 240V | RS Components - https://uk.rs-online.com/web/p/fuse-switches/1993925/
is in my kitchen and recently got smashed by someone dropping a very heavy chopping board. The insides look ok but the housing is now useless.
The switched...
I am not an electrician (as you will see from the question!) and I am not planning on doing any electrical alterations. My question is one of safety. I wanted to move a couple of sockets on a kitchen ring main. So I switched off that circuit on the RCD board and all the sockets were then dead. I...
Hi guys,
I've just had some refurbishment work done in my property and unfortunately the builders have run off. As a result the local building control department have had an eicr carried out and one of the points raised was the builders extended the ring straight into a shaver socket then onto...
Hi, newbie here, I'm currently doing my level 3.
Is the following set up ok -?
Outside lamp set up to come on with a PIR, but also want to over ride with a switch.
Just not sure if it's ok to have the switched live from the switch 'livening up' the switched live side of the electronic switch...
can anyone help with the connection for the switched live from the bathroom fan in this fuse box. it is the unconnected yellow wire with a red sleeve and i assume it goes into the top right OUT connection with the single red wire. Thanks in advance
I have an entry way that has 3 switches. One for the hallway, one for the front porch, and a third for a study outlet which is a room off the hallway.
I want to convert the switched outlet to a ceiling light that I am installing in the study. I would like the outlet to always have power and...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc