unit | Page 2

unit

Recent contents View information Top users
  1. T

    EICR consumer unit advise

    Hi, I am due EICR test on my property which has 20 year old wiring. Last test on 2018 was fine with no issues. Just need to check if my consumer unit will need replacement for EICR pass or it will be ok. Attaching pictures.
  2. G

    No power to part of the consumer unit

    Hi, The `power went out throughout the house this afternoon but only to the sockets, the lighting circuits are all fine. I went to the consumer unit expecting to reset a circuit breaker but nothing had tripped. I have attached a pic of the consumer unit. Using a current detector pen I can...
  3. Adam00

    Can you feed a consumer unit from another consumer unit?

    Can you feed a consumer unit from another consumer unit, It would be supplied by a non RDC protected MCB. Is this allowed as I have always seen switched fuse disconnection units.
  4. D

    NICEIC Certification Scheme SPD on old consumer unit?

    Under amendment 2 of the BS7671, there is now a requirement to fit an SPD as standard. I am due to install a new outdoor socket circuit on an old consumer unit which doesn't have an SPD. Is it ok to do this installation without the SPD?
  5. littlespark

    thin under unit LED light

    Ive got an old T5 (or4?) fitting to change to LED, but its built into the kitchen cabinet between two shelves of glass. Is there any like this: 13W LED Slimline Under Cabinet Link Light 4000K - https://www.cef.co.uk/catalogue/products/4228924-13-watt-slimline-led-linklight but only 18mm wide...
  6. homebuyer2023

    Buying flat, Consumer Unit replaced but no notification

    Hi All, I am in the middle of purchasing a small 1 bed flat in England, and have been sent a Domestic Electrical Installation Certificate by the seller (horizontal red form with 6 pages). The certificate states work was done 4 years ago including new sockets, downlights and a 'new consumer...
  7. V

    Advice on New Consumer Unit Change Please?

    Hi Everyone, Last year arranged for my mother's and my consumer units to be changed by the same electrician who is NICEIC registered. Both jobs were not completed for various reasons, I have been trying to arrange for them to be completed over the last two months. At my home the oven began...
  8. HappyHippyDad

    Type A RCBO for this consumer unit?

    Hello all.. I'm quoting for some work and would like change the type AC RCBO to a type A. Consumer unit is a castlec which I have not come across before. I can see from their site they make them, but cannot find them for sale? Also, are they rebranded? Is there another identical breaker that...
  9. D

    EICR Wil my consumer unit need replacing?

    I've booked in an electrician to run an EICR, I have an old unit here, whilst searching for quotes one guy said it looks ok and may not need replacing. The guy I've booked in says it likely will. My question is Is there a way I can witness the unit failing tests? How do I know it will fail or is...
  10. T

    Replacing MK Consumer Unit. Main switch position

    Hello mates. i have an MK CU to replace. As you may know, the main switch in MKs is on the left hand side. There's no way to replace the meter tails. Is there another manufacturer that has a left-hand main switch CU, or a flexible position option? Thanks muchly!
  11. S

    RCBO in office consumer unit

    Hi all Now being upfront I am not a sparks. I am about to have some work done by a friend (certified) and as he is doing me a favour I want to as much ground work and speccing up as I can. So heres the situation. we have a summer house at the end of the garden which is being fed by swa from a...
  12. R

    What diversity factor to be applied to a three phase food holding unit?

    Hi there currently doing some diversity calcs for college work and had a query about what diversity factor to apply to a 16A 3 phase commercial food holding unit. I'm thinking that this equipment will be only used in the day time(breakfast, Lunch and Tea (what we call the evening meal- dinner...
  13. A

    can a consumer unit switch be replaced by an RCD?

    HI My flat just failed the EICR because there is no RCD in the consumer unit. There is no space for a new RCD as the consumer unit is full. Do I have to have a new larger consumer unit installed? Or can I have the existing on/off switch replaced by an RCD? Thanks Alan
  14. Connor Lyon

    Unit 104 assignment.

    hi I'm currently doing the unit 104 design assignment but need to print a new copy out does any one have a blank one they could send on here?
  15. B

    Wood Cabin Consumer Unit

    Currently I have a Henley block which has 2 consumer units. 1 of these CU feeds a garden supply and garage. Out in the garden which is fed by a 16mm 3 core swa and is fused at 63amps with rcbo feeding sockets lights etc. I have now built a cabin further down the garden and want to provide...
  16. D

    Domestic electricity Spain: How to replace old ICP switch in consumer unit?

    Hola! I’m in the process of renovating an apartment in Madrid. The consumer unit is fitted with an old 15amp ICP switch. I believe its function is now handled by the smart meter, so it is redundant. As this is limiting the power available to the property I would like to remove it. My...
  17. O

    Consumer unit install in a camper van.

    Hi I am converting a Sprinter van. I would like to use RCBOs. I want to run 3 seperat Circuits. 1 and 2 for sockets either side of the van and third to a Truma combi boiler. I will be connecting up a Victron Multiplus 2. So please correct me if I have this wrong. The 230v socket will be close...
  18. M

    Making up a consumer unit

    Hi all, First time post to the forums, I hope you all go easy on me! We are undertaking an electrical install as apart of a solar PV installation. We have a very small electric meter cupboard on the front external wall of the clients house and they're not keen on an external enclosure on show...
  19. TradeNSW

    Cable from the main switchboard to the sub board in a unit

    Hey guys, thinking of relocating my sub board in my unit to a new location. Does the cable from the main switch Board to the sub board need to be a continuous run or am I able to put a junction box and extend the main cable to its new location?
  20. L

    Design Project unit 104

    Hello, I’m currently at college doing a design project which is based in a hotel/swimming pool area. I have been given an example but it doesn’t make to much. I have a question on how to wire the lighting and how to have it switched. If someone can help that would be great. I can show you...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top