24v DC driver for LED lights.

[Jay92191]

Hi all,

Can anyone recommend a decent 24V DC constant voltage LED driver.

It’s for an install of bathroom niche LEDs IP65 downlights. They are mini and have a 35mm cut out. The 1.5mm T&E is already dropped to each cut out but need a driver that will fit through a 35mm whole and to be pushed up.

Many thanks,
Jay

 

[plugsandsparks]

Hi all,

Can anyone recommend a decent 24V DC constant voltage LED driver.

It’s for an install of bathroom niche LEDs IP65 downlights. They are mini and have a 35mm cut out. The 1.5mm T&E is already dropped to each cut out but need a driver that will fit through a 35mm whole and to be pushed up.

Many thanks,
Jay

google tridonic led drivers, go to the tridonic website , find the right one for the power required and check the dimensions, get product code and order through your favourite supplier

 

[Jay92191]

google tridonic led drivers, go to the tridonic website , find the right one for the power required and check the dimensions, get product code and order through your favourite supplier

Thanks. Had checked them already and can’t see one small enough to fit through a 35mm hole.

 

[Jay92191]

LED Lights & LED Lighting Solutions | Ultra LEDs

www.ultraleds.co.uk

Found this in the end. Will have to go for a linear one as it’s the thinnest!

 

[brianmoooore]

That's over 34mm 'across corners' so will have to go in almost vertically. Do you have 305mm head clearance?

 

[Jay92191]

That's over 34mm 'across corners' so will have to go in almost vertically. Do you have 305mm head clearance?

Yeah head clearance all the way to the ceiling as there are no across noggins, so it will have to go vertically. Just a shame there are no smaller drivers that fit through a 35mm hole.

 

[Ursanelec]

The cut out is 35mm but what about the width of the downlight with the bezel? You can gain maybe a few more mm so you could possibly cut a 40mm hole instead, just saying...