Spot what's wrong

[Redvanman]

For the eagle eyed out there, can you tell me whats wrong with this arrangement and for a bonus point what reg. no. would apply.

The only bit of info you need is that its a TT system.

 

[Bobster]

Something else, circuit ID may be present on the cover, although I tend to fit core IDs as well.

 

[tony mc]

Would it be that all the L1 & L2 MBC's would be useless !

 

[Bobster]

No there's a single phase link kit fitted, you can see it just above the main switch

 

[sparkdog]

Its a metal cased cu on a TT system.

 

[Pete999]

Has he got the N cable in the wrong terminal at the intake? can't quite make it out eyesight going, or the Diazipan is blurring my vision

 

[telectrix]

RCD on the tails then.

 

[Bobster]

The OP has got a list of faults, I'll wait until he posts it up to see if he's got it.

 

[jaypp]

..............

 

[jay sean]

No RCBO for ring final ccts

 

[Pete999]

TT system No RCD???????, post 24 can't see any Ring Final circuits marked, only saying

 

[Redvanman]

Sorry had you go do a job.

Right the list of problems I noted were and you cant see most of then:

No neutral link between main switch and neutral bar therefore only single pole isolation on a TT system.
No grommet/ bush/gland for incoming tails therefore a RCD required as main switch or before board. If glanded correctly then RCD not needed as the meter is below
All lighting circuits have no cpc with metal switches and lights in use. Even through the cable entering the board has cpc. Under the board theres a piece of 2x2 plastic trunking stuffed full of the old cables all thro crimped to extend into new board. The old cable has no cpc but new cable does.
No testing was done before or after the install.
No labels except RCD warning (I no some of you dont like labels but its in the book)
No circuit chart

Someone made a note re ring circuits but all circuits do have RCBO's but in picture you cant see the left hand side fully.

Take a stab at how much he was charged and any thoughts on the reg no yet.

 

[Bobster]

You've missed some

 

[Redvanman]

You've missed some

Go on tell me

 

[davesparks]

Ferrules!

No cover over the ends of the bussbar.

No additional protection to the tails in metal DB

 

[davesparks]

And it looks like the neutral may be squished under the screw rather than between the plate and the moving 'cage' bit.