surface wiring inside container?

[Ross1]

Evening all,

I am pricing a job to run conduit for all accessories within a 20 foot container. the container is not getting internal lining.
As far as I know, containers are single skin. what fixings have you guy used in the past.

thanks

 

[Knobhead]

No Nails

 

[cdavies33]

I am guessing this is a shipping container that are used on building sites, etc.

If so pre-drill 3.5mm for 8's and 4mm for 10's... Then just send the screw home. Easy

 

[Leesparkykent]

Some parts of the container are normally double skinned, drill a 3.5 hole and thread it with a 4mm thread and use m4's to fix saddles up.

 

[Sintra]

Evening all,

I am pricing a job to run conduit for all accessories within a 20 foot container. the container is not getting internal lining.
As far as I know, containers are single skin. what fixings have you guy used in the past.

thanks

Secondary support goalpost and brace system made from unistrut. Then you can fix what you want where you want without damaging the container.

 

[netblindpaul]

Some comtainers are structural throught and not to be drilled.

 

[Knobhead]

Evening all,

I am pricing a job to run conduit for all accessories within a 20 foot container. the container is not getting internal lining.
As far as I know, containers are single skin. what fixings have you guy used in the past.

thanks

You have to determine the construction by going and looking. “As far as I know” is going to lead to a (expensive) mistake.

You can’t price a job unless you know for certain.

 

[Geordie Spark]

You have to determine the construction by going and looking. “As far as I know” is going to lead to a (expensive) mistake.

You can’t price a job unless you know for certain.

or unless you have crystal balls.

 

[Ross1]

Thanks guys, Im pricing for the worst case scenario.

cheers

 

[Darkwood]

magnetic saddles

 

[Knobhead]

or unless you have crystal balls.

Mines away for re-calibration, I think I’ve worn it out on here.

 

[shanky887614]

unistrut and ply simples, why make it difficult

 

[jimjimjim]

Weld uni strut on.

Jim

 

[Darkwood]

Weld uni strut on.

Jim

Thanks for signing out with your name.... in case we hadn't guessed it :dunce2:

 

[Engineer54]

Some comtainers are structural throught and not to be drilled.

That may well be the case for a working container being hauled on an off ships and having other full containers being stacked on top at ports and holding areas etc, but i don't think that would hold much water as a retired container now being used as say a static office, workshop etc....