Thoughts

[Poult12]

My college course required me to do this. Any thoughts?

FP200 has a bend in due to the position if the gland.

 

[Kate]

Loving the pigtail to the bonding. I do more curls though

 

[MDJ]

They are also given a wooden board to fit all that on, very tight and the holes may have already been in the dist board so his options may have been limited.

 

[telectrix]

go easy on the lad. he's at college. not sure of at what stage, though.

 

[dazza1981]

I think its more of an exercise in how to make off ends and get a feel for different cable and how there terminated. Good attempt mate and you will get better each time you do it.

 

[Silly Sausage]

Poulty, did all the sockets etc have to be where they are?
You could have made a much neater job if they were all vertical on either side of the board.

 

[Sintra]

My opinion.

From right to left. Grommet in top of switch not good. Random spacing of clips on t&e. Terrible looking u bend between switches. Random clipping of FP. Black glands on red cable. Can't see but round headed screws should be used for clipping. SWA random clipping and bent all shapes. SY same as before, looks as if it was installed by a 5 year old. Pyro could be a lot neater with time taken on the bending radius. Conduit not bad but more saddles properly spaced IMO.


In general cables leaving cu not parallel with each other. Cable lines should be vertical with properly formed bends. Accessories should all be in a straight horizontal line.

 

[telectrix]

and it will never work without a bulb in that pendant.

 

[GMES]

As dick emery once said you are awful but I like you .
There will be a few who have no idea what that means, im getting old

 

[telectrix]

and don't forget " dad, i've got it wrong again".

 

[GMES]

The Cocoon residents are stirring lol

 

[telectrix]

ye canna keep a good coffin dodger down for long.

 

[Silly Sausage]

Post Deleted, Poulty's replying

 

[Poult12]

Poulty, did all the sockets etc have to be where they are?
You could have made a much neater job if they were all vertical on either side of the board.

Unfortunately a pre-designed board including the conduit. My first real encounter with installing SY, MI, SWA, Data.

I knew it was bad but like someone else said it was more to do with terminations. I would post the inside of the board but im more embarrassed. Never had to put in a dist board before.

I knew putting it up would bring some difficult to take comments but end of the day i came on here to learn and you guys know your stuff.

 

[dazza1981]

unfortunately a pre-designed board including the conduit. My first real encounter with installing sy, mi, swa, data.

I knew it was bad but like someone else said it was more to do with terminations. I would post the inside of the board but im more embarrassed. Never had to put in a dist board before.

I knew putting it up would bring some difficult to take comments but end of the day i came on here to learn and you guys know your stuff.

good lad

 

[GMES]

Poult I don't know if I like the new humble you, can you please go back to being a cocky little 2 hat