tonights 2391 exam....(10th march 2011)

lynj · Mar 10, 2011

one thing to say and that is did c&g forget how to be staightforward?

felt like some of the questions were half thought......

anyone else take it?

sornen · Mar 10, 2011

What did you guys put for the three practical considerations before a periodic? ... And where the hell was the 1 over rt banker question!

filrobbo · Mar 10, 2011

fingers crossed...... I put the tripping time as 300 ms. wasn't sure.

nockster · Mar 10, 2011

Silly quote of the day, just before I leave for my exam my Mrs says "knock em dead babe", I tried to point out that this is exactly what the 2391 is trying to protect against lolololol.......

IQ Electrical · Mar 10, 2011

nockster said:
Silly quote of the day, just before I leave for my exam my Mrs says "knock em dead babe", I tried to point out that this is exactly what the 2391 is trying to protect against lolololol.......

She was reminding you of safe isolation...

LlandrilloSpark · Mar 10, 2011

Question asked you to IR test SWA section of lighting circuit only!, disconnect at the service cut out at base of column, so u didn't have to lower the test voltage because of photo cells

jimmy_one_ball · Mar 10, 2011

What did you guys put for the three practical considerations before a periodic? ... And where the hell was the 1 over rt banker question!

Hi soren I said there may be people in the shop, there may be boats banging against the jetties and there may be bad weather!! All i could think of lol crapp answers, what did you put?

sornen · Mar 10, 2011

I just left it blank and came back to it and guessed at notifying the installation users, checking for signs of obvious dangers and check earthing system! I didn't really get the question to be honest as I was focused more on what I need to do as part of the test and record.

sornen · Mar 10, 2011

With the ir test isn't it best to just quote the test as in gn3? I.e. Make reference to removing any voltage sensitive equipment or link out where applicable and not leave out steps based on the fact your just testing the swa?

Gra · Mar 10, 2011

what an absoloute nightmare!

Also done it tonight and flew through the first twenty realy happpy and then read the scenario!

It was SO unclear! How many dbs were there? i went for three in the end, one main, one shower and one shop? I dont understand how city and guilds being that unclear shapes us any better to test by being able to second guess them!

Completely buggered up the q.26 i worked out the safe touch voltage came out with 500ma like others, left and realised like many it was a special location on additional protection so 30ma :-( guttted. Also messed up the i.r test, put to test at 500v dc with combined line and neutral. Do that and disconnect the cut out fuses. bugger.

Can someone remind me of the 6 big questions again? got the fault path but only showed one db and the met in that with cpc and main conductor to the electrode.

Really annoyed roll on june

IQ Electrical · Mar 10, 2011

What was the special location?

sornen · Mar 10, 2011

Was it a special location? I had the same ir test voltage (500) but think that was correct.

LlandrilloSpark · Mar 10, 2011

Question specifically asked for IR test of SWA only so I didn't argue!, it also stated that the Columns were pre wired flex, that was to me another clue as to why the IR test stopes at the base of column

Rcd was it additional 30ma!, if so I'm chuffed as I thought I'd bollixed it up