Wiring of 3 Phase 63A Distribution Board

[ozj999]

I am planning to change my house's 20 years old DB to a new DB like in the website below:

http://www.electrolesk.com/Assets/db 3 ph web1.jpg

However, I am planning to use Hager 63A 10kA 3 pole MCB (model is: NC363A) instead of MCCB at the incoming. In addition, I plan to add in Hager Combined Over & Under Voltage Auxiliary, (model is: MZ214) and Hager type 2 SPD (model is:SPN465R).

Please advise on how to wire in both MZ214 and SPN465R in the DB.

Thank you very much.

 

[MDJ]

Hahahaha

 

[pepparz]

seriously think he will be electrocuted to DEATH before long.

 

[DPG]

That generator article is excellent. Daz

 

[MDJ]

He should get together with the new guy engineeer

 

[GLENNSPARK]

They will come with full instructions.

Not knowing the supply situation in Malaysia I don't think this is the best place to ask.

here Tony...found it:

 

[pepparz]

He should get together with the new guy engineeer

stfu haha

 

[pepparz]

hes added a disclaimer bit at the end to cover his arse

 

[MDJ]

"Removed" due to a childish reply

 

[Silly Sausage]

Just goes to show, don't believe a word you read on the interweb.
99% smut, the other 1%, bullshyte.

 

[GLENNSPARK]

Just goes to show, don't believe a word you read on the interweb.
99% smut, the other 1%, bullshyte.

1 thief...

 

[DPG]

"Removed" due to a childish reply

Doesn't normally stop you

 

[GLENNSPARK]

"Removed" due to a childish reply

2 thief

 

[Silly Sausage]

thief...

Any time!

Plagiarism is the only way.

 

[Darkwood]

Just looked at his calculations for no' of flourescent lights on a circuit... it would seem that in Malaysia induction isn't a concern to design .... seriously a very misguided ill educated site - full of errors some very basic and i would suggest the OP remove the site of the internet as it clearly gives in some cases worrying information....

This is no way a personal attack on the OP more a helpful warning that his website which even highlights England methods has not seen the 17th edition and he really needs to learn the basics on inductive load calcs.... i didn't know whether to laugh or just sit gobsmacked at the lack of understanding the site author has about a subject he probably thinks he has a good grasp of!!!

 

[Knobhead]

Don't worry about it DW, he's burnt the house down in the last nine months