door

  1. Pete999

    Help, door catch required for external meter box

    As the title suggests, does anyone know where I can purchase one, as Mick the Meter muncher came when I was out shopping, left me a note mind "sorry"
  2. L

    BELL WIRE FOR RING PRO DOOR BELL

    HI GUYS AND GIRLS, LOOKING TO INSTALL A RING PRO DOORBELL WHICH IS POWERED BY A 3 PIN UK TRANSFORMER NOT FROM A CU . MY QUESTION IS WHAT BELL WIRE TO USE PLEASE. REGARDS LEE
  3. M

    BLACK surface door contact

    How do all, does anyone know where I can purchase a black door contact from, my customer has just had a new door fitted and is insisting on a black contact.. Any and all help would be greatly appreciated.
  4. P

    EICR coding non Amend3 CU over front door

    Obviously at least a C3, but is it a C2? Front door opens into tiny hallway, not much more than 1m square with the stairs going straight up virtually in line with front door, approx. 300mm offset to right. Above you as you enter is a 16th edition insulated CU, tight against the ceiling and...
  5. B

    Red Spot/GEC Fuseboard, asbestos door seal/gaskets?

    Hi, I'm Ben and I work in various quarries around the Peak District where most of the gear is 70/80s. Asbestos reports on quarries are terrible and when you query things you just get told to not touch the gear. I have been doing testing and inspection of various small power items in the...
    • Ben Harris
    • Thread
    • asbestos door fuseboard red
    • Replies: 7
    • Forum: Talk Electrician
  6. T

    Vanderbilt codelock v42 Door keypad

    Hi, I've been asked if i could disconnect the above and then reconnect it as the pillar it is mounted on is being replaced. Would anyone be able to tell me what is involved as it isn't something I am familiar with? Is it a case of just disconnecting the unit and then reconnecting or is there...
  7. P

    Recommend an outdoor LED light for above back door and above patio

    Hi all Looking for recommendations on some outdoor LED lights to fit above my back door and also above the patio door. Not sure if they should have sensors fitted, wouldn't want them switching on and off all night, lots of cats in the area! Any opinions on good brands? Looking for something...
    • Prizen
    • Thread
    • door led led light light lights outdoor patio recommend spark sparks
    • Replies: 7
    • Forum: UK Electrical Forum
  8. L

    12v AC door release conundrum

    I need to put an exterior grade switch with a timer, to switch a 12v AC solenoid which is fail-secure- so it needs a momentary voltage to open the gate. All the electronic switches I am finding are 12v DC- but I need AC. I can't just use an ordinary push to make as I need a timer, so the...
  9. N

    WIFI Door Bell

    Hi guys Merry Christmas I have an E Prance WIFI door bell system but the batteries hardly last a week, the bell takes 3 x AAA batteries, Can I connect a mains to 4.5 volt DC transformer onto the bell without blowing the thing up. Many thanks Nick
  10. H

    Baumatic B180SS oven door hinge equivalents?

    Hi, looking to replace discontinued Baumatic B180SS oven door hinges? Anyone know a suitable model replacement? Thanks, K
    • hitchcockchaplin
    • Thread
    • baumatic cooker door oven
    • Replies: 1
    • Forum: UK Electrical Forum
  11. R

    Bypassed Door Entry System

    I wonder if anyone can help me concerning an apparently compromised Videx audio intercom door entry system please? The system has a problem in that unauthorised people (e.g. leaflet droppers) without keys/codes/being 'buzzed' in are letting themselves into a block of flats by doing *something*...
  12. P

    Door access system for flats

    Hi All, i did try searching the forum but I can't seem to open any of the post highlighted in the search results. I have been been asked to sort out a door entry intercom system with proximity reader for a block of 16 flats. All the usual suspects in terms of wholesalers are promoting the...
  13. E

    Class II Door switch

    Anyone know where I can get either a class II door switch or one with somewhere to terminate the CPC? The Jeani ones I've seen are not class II and do not have an earth terminal.
  14. J

    Roller shutter door motor wiring diagram

    Hi We are looking to replace an existing roller shutter door motor with the below Garog motor and wondered if anyone had a wiring diagram for this? Make: Garog Type: ULA25EE V 400 A 1.0 KW 0.5 RPM 28 PH 3 HZ 50 IP 44
    • Jase72
    • Thread
    • diagram door existing fitting motor roller shutter wiring wiring diagram
    • Replies: 4
    • Forum: UK Electrical Forum
  15. Jackflash

    keypad door entry: door won't open.

    HI, Been asked to go look at a keypad door entry system where it has been reported the magnet isn't letting go of the door on input of the code. Apparently a green light on the keypad illuminates on input of the code but door won't release. What's the most likely problem? It will prob be...
  16. N

    shop door chime

    hi all has anyone come across one of these its for the wifes dads garage it needs to be wired not wireless as had a few wireless and there all rubbish. basically i need some sort of pir sensor with a chime can anyonepoint me in the right direction cheers fellas
  17. Z

    Make my car wake me up if the door is open

    Recently I had multiple break ins into my car and seems like it is not going to stop soon. I was wondering if someone could give me an idea for a relative simple way to alert me when the car door is open. I know the car is already wired to beep and turn the light on inside when the door opens...
  18. J

    Fire Alarms, Door entry and Emergency Lighting coure

    Hi all Can some please recommend a good training provider in the London area for: Fire alarms CCTV/Door entry Emergency Many thanks
  19. egg67

    Next door 90 year old lady

    Got a call from next door neighbour today, my Iron is not working and every time the carer plugs it in she gets a shock off it, my son in law fixed it on Saturday and it was working ok when he left. Can you have a look at it for me Great use of black tape all taped up as one, what a fix from a...
  20. J

    Foot through the door

    Hi Everyone, I have just started a level 3 Electrical Installation diploma, which I am paying for myself, but it is only a 1 day a week course, and I dont feel like I am going to learn all that I can having a week off in between. I agree fully with the general consensus that the best route is...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Back
Top