Hi,I have fitted a timeclock throgh a contactor for some outside lights,and when I press the over ride on the time clock the lights only come on for a few seconds,then the contactor kicks,yet when I press from auto to over ride at the switch, they stay on, is this normal.I have read the...
Morning!
Going to be working near the coast and will need to fit earth bonding outside.
I originally chose stainless lugs to bond the copper cables but it appears that stainless and copper are not a good mix due to corrosion so I will stick with the standard copper connections.
I have seen...
Currently my builder is placing the cables straight under the slabs between the hard-core and cement. Should he be doing this or do they need to be insulated?
i have completed a wall and patio for my sister
i was going to progress with the electrical work myself
but been told NOT TO
so taken heed to wise words
i have now contracted 9 local electricians
for a price not one reply as yet
so my are plans are installing 8 outside lights and 5 outside...
Evening chaps
First fixing a new build this week I’ve got a dilemma I’ve not come across before, the meter box is outside and the consumer unit is to go in the garage it’s on the same wall about 1.5m away but the meter cupboard is outside on faced brickwork and the consumer is inside the garage...
Hello I have a 200 amp service that I want to turn off to install a mini split that’s located outdoors. What would be the correct steps to do this??
Indoors I know all I’d have to do is pull down the 200 amp breaker. Is it the same as outdoor or do I have to turn it off by the meter?
Hi Guys, please can you give me some advice. We are having a rewire and the electrician has installed an outside light with the wire sticking out as shown in the image below. He said that there is no way to have the wire inside as it comes from the floor which is below the fitting. Is that...
You might want to turn the pic on its side, appoliges!
Here we have a diagram of outside lights. The 2.5 cable is coming from the C/U to the light outside then onto the switch. It's on its own circuit with nothing else added.
Theres a separate socket on the other side of the wall which has...
Hi, I’m a qualified electrician but off the tools now. I was giving a neighbour a little advice for lights in his drive. Advised to run armoured to locations for lights and PIR. He had another spark round for a look and price to connect cables up and install the lights. I advised to make...
Hi. I have an outside porch light which has a switch just inside the hallway. I am adding 2 more outside lights to be switched on using that same switch. I have ran 1mm cable from the switch line and neutral & earth to the new light and continued that to the 2nd new light. When I switch the...
We have a garden footpath 16m from front door to garden gate with a shed near the gate.
I am looking for the following set-up:
a) an independent PIR sensor x2, one at each end of the circuit
b) these to operate 3-4 LED spikes or low level spots between the two
c) plus a floodlight to light the...
hi all,
i was directed to this forum by my neighbor seeking some advice and help
at present, I'm having my front garden dug out so I can make a driveway for my mobility car.
i was wondering, one day I will be getting an electric car, so if I have opportunity to lay cable now before they put...
Hi People on an install I have come across a British General outside socket that is reducing the Insulation Resistance when i remove the outside socket the IR goes back up has any one come across this before
Thanks phil
Hi all
I am on a TN-C-S / PME supply and have an outside tap, I have fitted it with 5 speedfit plastic elbows and a speedfit all plastic valve. So having so much plastic in place that should be the recommended insulated section of pipe to prevent dangerous voltages being on the tap in the event...
Hello everyone,
I hope you’re well.
I have a problem with my Optima Compact Gen 3.
I don’t know how can I change the outside bellbox, sounder without raising the alarm.
If you have any idea please let me know!
Thanks
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc