I over the last few days and noted that the room thermostat,located in the hall,comes on between every 10-13 minutes and stays on for about 20-23mins and then this cycle constantly repeats throughoout the day.
Room thermostat is a Honeywell T6360 with lamp and is set to 20c. I also have a wall...
Does 6mm2 SWA fit into 25mm Blue MDPE Pipe. The idea being to protect the cable from damp soil or water ingress when it is buried, not for mechanical protection. No tight radii to worry about just a 10-15m straight run.
Hi all, I'm not an electrician but i need some advice before i hire one to help me complete an installation which was started by a chap who has let me down. I have a large inline fan which sucks air from 4 rooms. it is supposed to be triggered by the lights, which are pir's, in each of the rooms...
Hope someone out there might have an idea of the best product for the job.... Basically our honeywell st7100 gave up the ghost this evening, I've adjusted the wiring so that both the room stat and cylinder stat control the boiler so we have hot water and heating for now, the zone valve has been...
Hi not sure if this can be posted here but it wont let me post to the diy'er forum!!
I have a ferroli domicondens f boiler which is volt free and i have a towerstat rf wireless thermostat to wire to it but am a little confused as how to wire it in!I have found the loop i need to wire to in the...
Hi all.
Have come on here for some help and advice. Im not an electrician.
My room stat, working fine last winter, thinks that the room it was located in (hallway) is 23 degrees (thermometer says currently about 16 degrees). Consequently I cannot set the stat to call for heat from the boiler...
hi all, having an issue at work where the heating wont turn off. wiring is all ok and been tested, the stat is switching fine although it is reading 24v at the switched live at the stat when its turned down which im thinking is a backfeed from the boiler of some kind.
Have replaced a few stats...
What's your take on a plate switch controlling a light in an en-suite shower room?
It's positioned outside the shower room on the wall by the door, but could be touched by someone standing inside Zone 0 (on the shower tray) if they put their arm around the door/corner?
Yes, it's unlikely, but...
Hi, just wanted to clear up some things, could anyone tell me when it became compulsory to install ip rated spots in shower rooms and also what you would code non ip rated spot installed prior to this date.
2 spots are above bath with shower and 2 are outside zone 2.
RCD's are present on all...
Water has been going down from the bath into my front room ceiling. There is obviously a light there. Since this has happened the light does not work anymore. My husband said there's no current for it to work so it's basically dead. All the other light in my house work perfectly fine. It's been...
Hi, not been wiring for many years, doing a project for family (love job) and would appreciate some advice please , apart from don't do it!
Rea;y question is.....how to physically to the job to BS7671 standards. Owner has requested that the En-suites light switches are wall mounted outside of...
Hello,
First post here, hoping that someone can help.
Moved into a 1935 house that has 3 bedrooms upstairs, all with Halogen spotlights in.
They all have dimmer switches on the walls, problem is that we have noticed - If I am in the Master Bed and the Wife goes to either the Box Room or...
I have a customer enquiring about a system for heating to control any floor heating, radiators hot water independantly for each room of house remotely or from a central control panel. Does anyone have any experience in any makes that suit the job best?
Right you reg's experts - ive pawed through mine and can't come up with an answer I am happy with. I have a shower/utility room, with a fixed cubicle shower with basin. First question: Can I run the (IP) rated shower cubicle light and ventilator fan from the ceiling isolator via an FCU, so that...
Renovating a house at the moment and the mains position and consumer unit was in a little toilet room. It is now being turned into a shower room and cost to move meter is too much for the client.
It is just out of zone 2 but obviously still needs a boxing in of some description. What degree of...
Evening all,
I want to fit ceiling speakers in my student house i rent out, I want to put 2 ceiling speakers in each room with a av plate on wall so they can plug in there phone, i pod etc and also want to be able to put a jack plug from tv into wall plate so they can use speakers watching tv in...
At a building I work at they have a gym with changing rooms.
Within the changing rooms are shower cubicles, these are completely enclosed cubicles almost like small separate rooms.
Originally they had fix head showers in the shower part of the cubicle. But these have since been changed for...
Hi everyone, I'm currently re wiring a house and need to put cables in for future multi room audio setup.
all tv and music equipment will be in a cupboard on landing.
im thinking of wall keypads/ amplified keypads for each zone/room.
does anyone know what cabling will be sufficient to pick any...
Hi I wondered if anyone could help out!
What are the regulations for a boiler in a wet room? the room is about 3 x3 with the shower in one corner and the boiler in the other, its not in touch distace from the shower but being a wet room does the total floor space become the shower try??
The...
Would appreciate some advice on the following:
The project has over 20 large apartments between lower ground floor & 3rd & there are 2 basement levels.
The client would now like to save space within the apartments & locate a small plant room within the basement garages.
Has anyone encountered...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc