Can’t access main bond to water pipe.....

Baddegg

-
Esteemed
Arms
Supporter
Patron
Can’t access connection of main bond to water pipe due to being (I assume under hardwood flooring) have confirmed continuity by disconnecting the 10mm at Met clamping on and testing with wander lead to copper pipe where it enters out of kitchen floor, but I can’t confirm the condition of the clamp,how would I record this on EIC? Or is just confirming continuity sufficient?
Incidentally the gas meter is at the top of a wall in the middle of the house,can visually see that clamp...
 
Last edited:
You were changing kitchen cupboards ?
Lol yes kitchen and bathroom refurb murdoch,am only a domestic installer and quite content with it, run a small building firm,done previous Cu changes but mostly on full refurbs of a property so any issues like this easily resolved as mess not a problem.
 
Gift then where the pipe comes up ?
If it is an old property it could well be lead or cast fed.

Lol yes kitchen and bathroom refurb murdoch,am only a domestic installer and quite content with it, run a small building firm,done previous Cu changes but mostly on full refurbs of a property so any issues like this easily resolved as mess not a problem.
 
Gift then where the pipe comes up ?
If it is an old property it could well be lead or cast fed.
First sign of any water pipe is in 15mm copper as it comes up from the kitchen floor,whole house done in oakish type flooring over flooring joists then from kitchen onwards it’s all concrete flooring, continuity was 0.02 short of ripping the place to bits can’t see what else I can do other than make a note on the cert ya know?
 
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

Advert

Advert

Thread statistics

Created
Baddegg,
Last reply from
Baddegg,
Replies
63
Views
10,539

Advert

Back
Top