Sorry if this isn't what this forums for but I'm at a loss and any help would be greatly appreciated, can anybody identify what bulb i need for this fitting?
It's an outdoor light if that's any help,
We have just bought this dimmable (three-stage) lamp.
The descriptions states: "Bulbs required 1 x golfball SES small edison eco halogen bulb"
Do you think it has to be an E14 dimmable "eco halogen" bulb? Or do you think I can I get an E14 dimmable LED bulb?
Hi guys, I am a DIY homeowner and the light in my bathroom went out. I stupidly threw away the bulb without checking the connector but I noted down the model number. It was an osram dulux el longlife 20w/41-827 but I can't for the life of me find it online. I have attatched 2 pictures of what...
So I was changing a lightbulb with a wide bayonet base to it. The actual glass bulb itself has come away completely, but the bayonet base and contact wires are still stuck in the light. How do I remove this?
Hello,
I have recently had a Led downright/ extractor fan combination unit installed. After approx 10 mins the light begins to flash intermittently (as attached). The bulb installed is a 3 watt bulb. I swapped this out to a 4 watt bulb and the flashing increased. The electrician whom installed...
Hi all. We're going to be replacing some edison bulbs in our patio with LED lights. I'm not very familiar with safety when it comes to LED's. This article from LED Lights Unlimited was pretty good about checking the bulbs and wiring, but I'm interested in knowing how they'll do outside this...
I just finished painting a bedroom and replaced the LED lights that were previously to small for the recessed cans with bigger LED lights of the appropriate size. While painting I only had 2 of the 4 new LED lights installed plus another LED light of a different size and left the other one...
Hi, I've "inherited" a light fitting which I believe used to work okay but then stopped. I've tried swapping the "bulb" (it's not a bulb!) but it's still not working. I'm unfamiliar with the fitting so I'm concerned if I've bought the wrong sort of bulb, which I tried to match with the old one...
I have this bulb that needs replacing. Markings on it are: 2817, 240V 150W, C2b8, Germany. What type is this please? Also, can I replace it with 150W LED equivalent?
Just the ceiling lights (3 rooms + bathroom), all wall sockets working fine & no circuit breakers popped out. Any ideas why? Someone said it could be rodents chewing the cables & my upstairs neighbour has had a few infestations recently:mad:. I'm in a Victorian terrace ground floor flat.
Does it...
Hi
I have been trying to change an led gu10 bulb in a recessed spotlight in my hallway. On others there has been enough cable to hold the bulb and twist it to change, but this is too short, so I cant hold the connector still to twist the bulb.
I have tried pulled it with pliers, and also...
Hello, experts!
My questions are:
1) Most importantly... is this safe to use electronics wired as you see in my image below?
2) Why did my light bulb explode?
First of all I have European plugs, not UK ones. As you already can guess my light bulb explode. It happen while switching on a table...
I have recently installed a ceramic bulb holder onto the ceiling of a virarium (a tank for a reptile). The bulb holder holds an infra red heat bulb to provide a basking area for the lizard. The bulb holder is screwed directly onto the ceiling of the vivarium which is made of chipboard. The...
Since we moved house, the light above the front door hasn't worked. Picture attached.
Looking at it, does anyone know how to remove the lamp? The black fixture tilts in the outer holder but I don't know if that's just designed to allow the bulb to be angled.
Hope someone can help, went to replace sensor bulbs (incandescent) with leds when the bulbs went off or switched off they stayed on but with a small glow. I disconnected feed to utility light and lights went off no problem reconnected problem started. Is there a way to fix this problem, thanks...
Mrs has a vanity mirror with lights, one holder has packed up any chance from pics you guys know where I can buy one? They are SES holders I’ve looked but can’t find the same as this found ones similar
Thanks
Hi all,
My name is Josh & I'm just starting to get into electronics and working on some projects to further develop my skills however have reached and impasse so seeking your assistance. Nice to meet you all :)
I have some basic electronics skills from messing around with breadboards etc to...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc