Hi all,
I'm wondering if it's permitted to replace an outside wall light myself if I use the existing wiring from the old light. In theory I just need to fix new light to wall and connect the wires to the terminals. I had assumed this would be ok because I'm not adding additional wiring. To me...
Hi All,
I've installed a Lorex doorbell recently, but it is not turning on.
I did some tests using a multimeter and this is what I found:
Transformer voltage: 29v (transformer specs: Heath Zenith: 24v 20VA transformer)
Chimebox (between Trans 3 and Front 2 screws): 29v
Back of Doorbell...
Hello, I’m trying to change a pendent light, I’ve wired it the same as the previous light that was on there however the light is now permanently on and the switch does not work, there are two line wires tied together, two neutrals and an earth wire. I took off the new pendent light and I wired...
Hey guys
I'm going back into college and I have had some time off and behind work.
I just can't get my head around this.
1 gang 2 way plate switch and intermediate plate.
Can someone help me with how I would wire this circuit with an intermediary switch. ( using a triple core and E cable for...
Hi all,
I have a log cabin in my garden. An electrician ran an armoured cable from my consumer unit to the log cabin and this terminates on the outside in an exterior junction box. From there, there is a single circuit in the cabin that supplies two external security lights plus power sockets...
Hi
I also posted this on the DIY Electrical Advice - Electrical Appliances Forum
My Kitchen has never had a cooker hood installed.
Where the new hood is going to be situated is some distance from any of the outlets in the kitchen ring main.
However there is a cable coming out of the wall near...
Well....wiring in a 1750s thatched cottage attic, not wiring made from thatch 🤪
One we have been letting for over 20 years (as well as enjoying ourselves!)
I have read Thatch Roof Wiring - https://www.electriciansforums.net/threads/thatch-roof-wiring.106532, but welcome any ideas for us.
We...
Hi, I need some advice on the wiring for a new ceiling light. I have taken down the original light, and I'm left with the wiring in the image ceiling_wiring_01.jpg. There are three cables coming off a connector block in the ceiling, each with a live and neutral and a single earth wire on its...
A simple outlet, 110v a single (2) outlets on the left side of the box, a spst switch on the right, with a single cover, covering them both.
The switch on the right controls an overhead light, and is unaffected since it's wired by itself. It merely shares the same box.
The outlet on the left...
I’ve got the following setup on the stairway (picture included)
https://pasteboard.co/15IoYrvn2VgA.webp
https://pasteboard.co/2UzMaHCbs1iE.webp
My guess is it’s for the stairway light.
The setup is: 2 red wires twisted together 2 black wires independent from each other 2 earth wires twisted...
Hi - we have an inline heater for a vent system that appears to always be on. I believe the electrician may have wired it incorrectly with only a 2 core wire from thermostat to heater control board. Please find attached wiring diagram and photos of the heater control board and the thermostat...
Hello,
I live in Costa Rica, which adopted the US electrical code.
On a regular basis, during thunderstorms, I have parks coming out of the outlets and damaged devices, but no breaker ever flipped. I asked an electrician here and he told me everything is fine.
I looked into the wiring and found...
I've wired up my spots however the main light [the one that was once a ceiling rose] works as intended with the light switch, but the rest are permanently on?
What have I done wrong?
The spots do not have In and Out terminals as part of the fitting, only a blue and brown connector block.
I have two supplies into a new horstman e7 box, 1 from the offpeak water heating one from standard tariff boost do both suppies go to 1 and 2, 4 &5 linked, when wired this way boost RCBO trips ,if I remove the off peak it works albeit no off peak I fitted 2 new RCBO boards a while back but there...
Hi,
I have a Friedland 752 chime box in my living room which is the most ugly thing. We have not had a doorbell attached to it in the 5 years we have lived here and are decorating and now is the time for it to go.
There is a transformer in the cupboard along with the board.
Is it a case of...
Hi,
I'm wondering if I can wire In an additional brake light bar. I have a caravan that has twin filament bulbs. I'm looking to add in a break light bar. Is this possible by splicing into the existing system
Hey everyone complete idiot here😂 can anyone please help me with what goes where if possible by these pics? There is one black and one grey wire, rest brown, blue and ground, cheers!
Hi folks,
I’m new to the forum and it’s this issue that lead me here.
So first things first. I was looking to wire in a Smart Relay at the rose of my hallway light. It’s got two switches. Now I thought I had “ok” knowledge when it came to wiring a socket / light switch / rose.
However...
i am wiring up a new en-suite: it is about 1.7m square, shower cubicle in one corner, toilet in other, door between, basin next to shower.
I will fit a wall-mounted convector heater next to the door, well away from the shower, so i dont think it needs to be the IP rated version and i will fit a...
Hello, I currently have two switches in my bathroom. One controls the lights above the sink and the other controls a light above the toilet and also a fan. I want to separate the switch from the fan and have that separate. I got a nutone fan that has a wireless remote, so I don't need wires to...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc